2. BLOTZ
  3. B15-PS-001

BLOTZ B15-PS-001 Assembly Instructions

  • I have reviewed the instructions for the Blotz Cooling Tower B15-PS-001 model, which includes details on how to assemble the 15mm scale tower. The instructions provide guidance on using glue, cutting tools, and how to hold pieces together during the process. I'm ready to answer any questions you have about assembling this model.
  • What kind of glue is needed for assembly?
    What tool is needed to remove sections from the sprue?
    What can be used to hold pieces in place while the glue dries?
15mm Cooling Tower
B15-PS-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the base and triangle supports from the
sprue.
Glue the supports to the base.
Attach the lower ring to the supports, gently
moving each until its lugs go into the holes.
Each side piece is formed from the pieces shown
above.
Once they are glued into place, they should look
like this.
Glue three side pieces to the lower ring as shown.
Glue the top ring into position.
Work round the tower, adding each strip in turn.
Place its bottom lugs into the lower ring, then
gently ease it into the top ring.
/