BLOTZ B15-PS-001 Assembly Instructions

Type
Assembly Instructions
15mm Cooling Tower
B15-PS-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the base and triangle supports from the
sprue.
Glue the supports to the base.
Attach the lower ring to the supports, gently
moving each until its lugs go into the holes.
Each side piece is formed from the pieces shown
above.
Once they are glued into place, they should look
like this.
Glue three side pieces to the lower ring as shown.
Glue the top ring into position.
Work round the tower, adding each strip in turn.
Place its bottom lugs into the lower ring, then
gently ease it into the top ring.
  • Page 1 1

BLOTZ B15-PS-001 Assembly Instructions

Type
Assembly Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI