Workrite 101 Chair Installation guide

Workrite
Brand
Workrite
Model
101 Chair
Type
Installation guide
1 of 3 Line of Sight | (800) 463-7731 | los.workriteergo.com
10 mm
5 mm
Hex
6 mm
6 mm 14 mm
M6 x 1 mm Thread
A Swivel Base
Qty: 1 B Casters
Qty: 5 C Compression Cylinder
Qty: 1 D Seat Base
Qty: 1 E Seat
Qty: 1
F M6 × 14 mm Allen
Head Screws
Qty: 4 G M6 Flat Washer
Qty: 4 H 6 mm Allen Wrench
Qty: 1
Line of Sight CHAIR 101 Installation Instructions:
LOS-101-PB-GB
Parts Included
1 Insert Casters into Bottom of Swivel Base
Insert the five Casters (B) into the bottom of the five legs of the
Swivel Base (A). Insert until they *snap* into place.
2 Insert Compression Cylinder into Top of Swivel Base
Insert the Compression Cylinder (C) into the top of the Swivel
Base assembly. Gravity will keep the Cylinder in place.
A
C
B
2 of 3 Line of Sight | (800) 463-7731 | los.workriteergo.com
3 Attach Seat Base to Bottom of Seat
Attach the Seat Base (D) to the bottom of the Seat (E) with the
four M6 × 14 mm Allen Head Screws (F) and four M6 Flat Washers
(G) using the 6 mm Allen wrench (H) supplied.
Note: Make sure the Height Adjustment Lever is on the right side
for a seated User when flipped right side up.
4 Insert Seat Base onto Compression Cylinder
Set the Seat Base assembly onto the Compression Cylinder. The
Cylinder's top post will slide into the receptacle on the bottom of
the Seat Base. Press firmly to temporarily attach in place.
Carefully sit in the Chair the first time to wedge the Seat Base
onto the Compression Cylinder. Your weight will attach the Seat
assembly to the Base assembly securely.
D
F
H
G
E
Lever on right for
seated User
3 of 3 Line of Sight | (800) 463-7731 | los.workriteergo.com
#1500416 Rev B
✓ Consult Workrite Posture Guidelines & Chair Setup Video
Consult the Workrite Guide to Good Posture to set up your chair for optimum ergonomic benefit.
For written instructions, go to: http://workriteergo.com/good-posture-guide/
For video instructions, go to: https://www.youtube.com/watch?v=DZOxIEG3o3o
5 Adjust the Seat Height position
To raise:
Take your weight o the seat, pull the lever upwards, release
the lever when the seat is at the desired height
To lower:
Place your weight on the seat, pull the lever upwards, release
the lever when the seat is at the desired height.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Workrite 101 Chair Installation guide

Workrite
Brand
Workrite
Model
101 Chair
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents