Midmark 647 Barrier-Free® Podiatry Procedures Chair Installation guide

Type
Installation guide
1
© Midmark Corporation 2008
MA7941i
J12
J12
J9
J12
Wireless Foot Control Installation [9A418]
Components:
Antenna ..................1
PC Board ................2
Nut ..........................1
Wire Harness ..........1
Foot Control ............1
Batteries (AA) .........2
003-1901-00 Rev. A
Step 1: Raise base shrouds.
A) Remove bottom screws from inner shrouds.
B) Stretch bungee cord across base column.
C) Lift shrouds, then attach bungee cord hooks
under shrouds on both sides.
Compatible with models:
647 (all)
Step 2: Remove PC board cover.
A) Remove two screws, then partially separate cover.
B) Disconnect wire harness from J12 on PC board.
C) Remove PC board cover.
(Rotational Base)
Caution
Always disconnect power to chair before removing
covers or performing any service procedures.
(Standard Base)
Step 3: Remove wire harness cover.
NextNext
BackBack
Style A
2
© Midmark Corporation 2008
MA773800i
Compliance
Label
Flat Side
J18
Equipment Alert
Antenna connection is very delicate.
Do not kink wire or apply stress to connection.
Step 5: Install / connect base station PC board.
A) Install PC board onto standoffs as shown.
B) Connect antenna to base station PC board.
C) Connect wire harness to base station PC board.
D) Connect other end of harness to J18 on main PC board.
Step 4: Install antenna.
A) Insert antenna thru hole in wire harness
cover with flat side positioned as shown.
B) Secure antenna with nut.
Step 6: Apply compliance label.
To complete installation:
• Installbatteriesinfootcontrol
• Checkforproperoperation
• Installwireharnesscover
• InstallPCboardcover
• Lower/secureshrouds
NextNext
BackBack
  • Page 1 1
  • Page 2 2

Midmark 647 Barrier-Free® Podiatry Procedures Chair Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI