Legrand Intellisense Sierra Mounting Plate - 364515-01 Installation guide
- Category
- Car kits
- Type
- Installation guide
This manual is also suitable for
1. Introduction
The OnQ Intellisense Sierra Mounting Plate is to be
used with the Intellisense Sierra S5832 Security
System and expansion modules. The mounting
plate can be installed in any OnQ Service Center
Enclosure.
2. Description
The Mounting Plate is a full-width plate that
measures 7.9” H x 6.42” W.
3. Installation
Mounting in OnQ Enclosure (refer to Figure 2):
a) Align tabs on the mounting plate with slots
in enclosure.
b) Insert tabs by angling mounting plate away from the back of the enclosure.
c) Rotate the mounting plate and insert fasteners on mounting plate into corresponding holes on rail of
enclosure. (Plunger must be in a pulled position for fastener to engage hole).
d) Push plunger in to lock mounting plate in place. Pull on plate to ensure it is locked properly in place.
OnQ Technologies, Inc.
P.O. Box 60907
Harrisburg, PA 17106-0907
800-321-2343
www.onqtech.com
Installation/Instruction Sheet
Intellisense Sierra Mounting Plate
IS-0168 Rev. O
IS-0168 Rev. O Page 1 of 1
Ref. P/N 100225-68
Intellisense Sierra Mounting Plate
Figure 2
Example view - placement in OnQ Enclosure
-
1
Legrand Intellisense Sierra Mounting Plate - 364515-01 Installation guide
- Category
- Car kits
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Legrand Power Strip Module, Full Width, IS-0084 Installation guide
-
-
-
-
-
-
-
-
Legrand 36446501 Operating instructions
-
