Eastwood Professional Cable Tie Gun Operating instructions

PROFESSIONAL WIRE TIE GUN

INSTRUCTIONS

Part #13704

The Eastwood Professional Cable Tie Gun allows quick, convenient, one-handed tightening and

cutting of cable ties up to 1/4” wide. Just set the tension, grip cable tie end, pull trigger, cut and you

are done. Cuts off excess cable tie cleanly with no sharp edges.

WARNINGS

• Do not use near live electrical sources or hot surfaces.

• Keep ﬁ ngers away from moving parts of tool.

OPERA TION

• Tension numbers from 1 to 3 are visible in the round window on the left side of the handle.

Turn thumbwheel in handle toward rear of handle to increase tension on wire tie bundle,

forward to lessen tension on wires.

• Create loop in wire tie by pulling end of tie through latch end as normal then insert free end

of tie into end of tool jaw.

• Allow end of tool jaw to come into contact with the latch end of the wire tie.

• Pull trigger repeatedly until cable tie is tight then the tool will automatically cut off excess end.

If you have any questions about the use of this product, please contact

The Eastwood Technical Assistance Service Department:

800.544.5118 >> email: techelp@eastwood.com

The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA

US and Canada: 800.345.1178 outside US: 610.718.8335

Fax: 610.323.6268 eastwood.com

Tension

number

window

Tension

adjuster

Download PDF