4-INS-TSA8002
CARRY IN LIMITED WARRANTY
All equipment, which is sold under ANVIL trademark and used for commercial purposes, is warranted against defects
in materials and workmanship. The warranty runs for one year from the date of original installation and is for the benet
of the original purchaser only. All other Warranties, Expressed, or Implied, Statutory or Otherwise, including Without
Limitation any implied Warranty of Merchantability or Fitness for Purposes are excluded. The Seller shall in no event be
liable for direct, indirect or consequential damages in connection with Anvil commercial products.
The Sellers obligation under this warranty is limited to the repair of defects without charge. Defective units must be
taken or shipped, transportation charges prepaid, to ANVIL.
This warranty is not effective if damage occurs because of accident, carelessness, improper installation, lack of proper
set – up, supervision when required of if the equipment is installed or operated in any manner contrary to the installation
and operating instructions. In these cases, repairs will be made at a reasonable cost. Work performed by unauthorized
personnel or unauthorized service agencies voids this Warranty.
On-site Warranty is only offered on items 110 lbs, or more, and gas equipment that is permanently installed
within a 30 mile radius of a certied Anvil technician. Please refer to our Product Catalogue for weights and
measures.
Items not covered under warranty:
- Meat Grinder Knives
- Light Bulbs in Convection Ovens,Popcorn machine & Hot Food Merchandiser
- Oven Door Seals
- Oven Door Glass
- Hot Food Merchandiser/ Display Case Glass
- Slicers–Where Blade has not been Sharpened (Refer Page 21 for Sharpening instructions)
- Changing Gears on the Mixers while Unit is Running and Overloading as Determined by an Anvil Certied technician.
WARRANTY PROCEDURE:
On all warranty calls, the following information is required:
-Name of person calling.
-Phone number of person calling.
-Business name.
-Street address, city, state & zip
-Model number (Found on serial plate)
-Date of Purchase.
-Proof of Purchase. (Receipt)
-Name of dealer where unit was purchased.
IMPORTANT
REGISTER ON-LINE TODAY
Register your warranty on-line now at www.anvilworld.com
NO WEB ACCESS
If you do not have access to the web, kindly register by completing the warranty registration
form and faxing it to the ANVIL ofce in the country of purchase.
Failure to do so will invalidate your warranty.
INSTRUCTION MANUAL
DOUBLE PLATE STOVE ELECTRIC
TSA 8002
Page 1
Page 6
UNPACKING: Unpack the product and check for any damage incurred during
transit. This should be reported to the responsible carrier, railway or postal
authority, and a request for a damage report should be made
THESE INSTRUCTIONS MUST BE FOLLOWED FOR US
TO GUARANTEE OUR FULL SUPPORT OF YOUR CLAIM
FOR PROTECTING AGAINST LOSS FROM CONCEALED
DAMAGE. THE FORM FOR FILING SUCH A CLAIM WILL
BE PROVIDED BY THE CARRIER.
!
GENERAL INSTALLATION AND OPERATION INSTRUCTIONS:
INSTALLATION, OPERATION AND CARE OF :
TSA8002 DOUBLE PLATE ELECTRIC STOVE
IT IS ESSENTIAL TO MAKE SURE THAT THE INCOMING
VOLTAGE IS THE SAME AS THE RATED VOLTAGE OF THE
OF THE UNIT AS FOUND ON THE SERIAL PLATE. THE
SERIAL PLATE IS LOCATED AT THE REAR OF THE UNIT
ADJACENT TO THE INCOMING CABLE ENTRY.
!
1. The top working surface has a heat resistant coating. Before using the sealed
hotplate for the rst time, it should be heated for +/- 5 minutes at setting no. 2.
This will enable the protective coating to harden and burn off.
2. Use only good quality pans on the sealed hotplates. They should have a stable
bottom to ensure the greatest possible contact with the sealed hotplate during
operation. This will result in maximum use of energy.
3. Use pans of the correct diameter only. They should cover the sealed hotplate
like an umbrella to allow any spillage to ow off easily.
Page 5 Page 2
CLEANING :
1. Always ensure that the stove is disconnected from the main power supply
before cleaning.
2. These units should not be cleaned with a water jet or immersed in water.
Use only a damp cloth or sponge dipped in soapy water.
3. Wipe off the unit with a dry cloth and wait at least half an hour before
reconnecting to the mains outlet.
THIS APPLIANCE SHOULD NOT BE CLEANED WITH A
WATER JET OR IMMERSED IN WATER. USE ONLY A DAMP
CLOTH OR SPONGE DIPPED IN SOAPY WATER.
DO NOT USE STEEL-WOOL WHICH WILL MARK THE
BRIGHT STAINLESS STEEL FINISH
!
CAUTION: DO NOT OPERATE ANY APPLIANCE AFTER THE
APPLIANCE MALFUNCTIONS OR HAS BEEN DAMAGED IN
ANY MANNER. RETURN APPLIANCE TO THE NEAREST
AUTHORISED SERVICE FACILITY FOR EXAMINATION,
REPAIR OR ADJUSTMENT
!
293
381
634
695.60
244
MODEL: TWO PLATE STOVE
MODEL CODE: TSA8002
VERSION DATE 11/06/08
4. If the pan is too small, energy is wasted and spillage can ow onto the sealed
hotplate.
5. Anvil stoves are equipped with one pilot light which will remain illuminated when
the unit is switched on.
Page 3 Page 4
SAFETY :
1. When the stoves are to be positioned in close proximity to a wall, partitions,
kitchen furniture, decorative nishes, etc. it is recommended that they be made
of non-combustible material. If not, they shall be clad with a suitable non-com
bustible heat insulating material, and the closest attention be paid to re
prevention regulations.
2. The units are designed to operate on alternating current only (A.C.).
DO NOT CONNECT TO DIRECT CURRENT (D.C.).
3. Care should be taken when operating the unit as HOT SURFACES are present
which may cause burns.
4. Ensure that the power supply cord does not come into contact with hot surfaces.
5. If the supply cord is damaged, it must be replaced with a new cord assembly
available from the suppliers agent.
6. Do not leave unit in operation without an attendant.
MODEL DESCRIPTION VOLTS V/Hz POWER
WATTS
TSA 0002 DOUBLE PLATE STOVE 220 / 60 2P 4000
ELECTRICAL CONNECTION INFORMATION:
DESCRIPTION
WIRING DIAGRAM.
4
1
P3
5
2
1
3
4
P3
P1
P2
3
2
5
P1
P2
S2
S1
S1 / S2
1 - SW - 7P
SEVEN POSITION STAGE SWITCH
E1
H1
E1
E1
E2
1 - PL - GP
5 - 2000W - SP
5 - 2000W - SP
CONTROL PILOT LIGHT
STOVE PLATE ELEMENT - 2000W / 220V
STOVE PLATE ELEMENT - 2000W / 220V
H1
E2
E1
PART NUMBER
LEGEND
MODEL: HOT PLATE DOUBLE ELECTRIC - 220V
MODEL CODE: STA8002
E2
H2
1 - PL - GP
H2
CONTROL PILOT LIGHT
E2
REV - 11/06/08
L1
L2
G
24 1 WH
WHBLK
220 V
1
2
6
5
4
3
7
8
9
10
11
12
Stove, Double Plate, 220v
MODEL CODE: STA8002
VERSION DATE 10/06/08
Stove, Double Plate, 220v
MODEL CODE : STA8002
Part
SCE
Description
No.
Part No.
1 5-2000W-SP 220MM SOLID PLATE
2 82-STA-SS-BDYAS 2 PLATE STOVE BODY ASSEMBLY
3 1-SW-7P 7 STAGE SELECTOR SWITCH
4 3-CP-ANVIL CONTROL PANEL
5 4-ANVIL-CP-IN-1 CONTROL PANEL INSERT
6 1-PL-GP PILOT LIGHT
7 3-KNOB-S/PLATE KNOB
8 4-ANVIL-LOGO ANVIL LOGO
9 7-FOOT-FTA7016 ADJUSTABLE FOOT
10 82-STB-SS-BOTCV BOTTOM COVER
11 5-2000W-BRACKET 220MM SOLID PLATE SHEILD
12 3-CB-3PHASE 3 PHASECONNECTOR BLOCK
VERSION DATE - 01/09
-
1
-
2
-
3
-
4
-
5
-
6
