Avtech VGA02A User manual

27Z

VGA02A_02_V1.3

* Please read instructions thoroughly before operation and retain it for future reference.

SPECIFICATIONS

MODEL 1 MODEL 2

Connection

DVR Side: MONITOR OUT

Monitor Side: D-Sub (VGA)

Output Resolution

Two Options selectable:

> 1024×768@60Hz

> 1280 x 1024@60Hz

Up to 1024×768@60Hz

Analog non-interlaced RGB Output

Support

YES

NTSC / PAL System Auto Detection YES

Power

External adaptor DC12V

@ 0.5A

External adaptor DC5V

@ 0.5A

Power Consumption (±10%) 2.5W 2 W

Dimensions (mm)** 87(L) × 64(W) × 24(H)

* The specifications are subject to change without notice.

** Dimensional Tolerance: ± 5mm

CONNECTION

STEP1: Monitor Connection

Connect the monitor’s VGA D-Sub connector to the VGA jack of the VGA converter (A to A).

STEP2: DVR Connection

Connect the VGA converter with a RCA cable with BNC connector, or a coaxial cable to

DVR’s main monitor output jack (B to B).

STEP3: Power Connection

Connect the power connector of the VGA converter to the regulated power adapter (C to

C), and plug the adapter to the power outlet.

RESOLUTION SWITCH (Model 1 Only)

STEP1: Turn the VGA converter to the rear side, and find a pinhole as indicated below.

STEP2: Insert a paper clip to the pinhole as indicated below to switch the VGA output resolution

to 1024×768, or 1280 x 1024. The current resolution will be shown on your LCD monitor.