AKM 474 PRODUCT DESCRIPTION SHEET
FR
5019 319 66033
Operation of burners with safety
device and electric ignition
To light one of the burners:
• Press the relative knob and turn it anti-clockwise
to the large flame and star setting .
• At the same time, hold the knob down until the
burner ignites.
• After the burner has ignited, keep the knob
pressed for about 10 seconds.
• Release the knob.
If the burner does not ignite, repeat the operations
described above.
Note:
— Should particular local conditions of the
delivered gas make ignition of the burner
difficult, it is advisable to repeat the
operation with the knob turned to the small
flame setting .
— The burner safety device shuts off the gas
supply to the burner if the flame goes out
accidentally (because of a sudden draught,
an interruption in the gas delivery, boiling
over of liquids, etc.).
— The separator panel, positioned beneath the
cooktop at a minimum distance of 20 mm,
must be sealed.
1. Radiant cooking zone Ø 180, 1700W
2. Haloring cooking zone Ø 145, 1200W
3. Large burner
4. Small burner
5. Front left cooking zone control knob
6. Rear left cooking zone control knob
7. Large burner control knob
8. Small burner control knob
Symbols
Shaded
circle
Tap closed
Large flame
and star
Maximum opening/delivery
and electric ignition
Small flame
Minimum opening or
reduced delivery
A wooden shelf must be
installed below the cooktop
with a minimum thickness of
20 mm, at least 15 mm from the
bottom of the surface itself.
3gb66033.fm Page 1 Thursday, May 22, 2003 9:28 AM