Internet Energy Systems C3I-W Installation guide

Brand
Internet Energy Systems
Model
C3I-W
Type
Installation guide
C3I-W WIRELESS MODEM
INSTALLATION MANUAL
THE C3IW IS A WIRELESS VERSION OF THE C3I FAMILY OF PRODUCTS WHICH IS
DESIGNED TO REMOTELY READ ELECTRICAL, GAS, AND WATER METERS AS WELL AS
PERFORM LOAD MANAGEMENT FUNCTIONS. THE C3IW USES TELEMETRY FREQUENCIES
IN THE VHF BAND TO ACCOMPLISH THIS.
THE C3IW CAN READ UP TO 4 METERS AND CONTROL UP TO 3 APLLIANCES.
Load Management
WHEN AN ELECTRICAL PEAK IS DETECTED AT A SUBSTATION, A DESIGNATED
CODE IS SENT OUT TO A GROUP OF C3I GATEWAYS. IN TURN, THE GATEWAYS WILL SHUT
OFF A DESIRED ELECTRICAL APPLIANCE FOR A SHORT PERIOD OF TIME VIA THE
ONBOARD RELAY CONTROL CIRCUIT.
Meter Reading
THE C3I GATEWAY CAN ALSO READ DATA FROM ELECTRICAL, WATER, GAS, OR ANY
OTHER TYPE OF METERING WITH CORRECT INTERFACING. WHEN METERS ARE TO BE
READ, THE SPECIFIC GATEWAY WILL BE POLLED BY THE BASE UNIT, REQUESTING ITS
METER READING DATA. THE GATEWAY WILL THEN SEND ITS DATA BACK IN THE FORM
OF DATA PACKET.
THE C3IW COMES INSTALLED IN WEATHERPROOF ENCLOSURE.
T1 BAR CONNECTOR CONTAINS ALL INPUTS AND RELAY OUTPUTS ALONG WITH DC
INPUT. ALL POSITIONS ARE CLEARLY MARKED FOR EASY INSTALLATION AS SHOWN
BELOW:
12 VDC + : CONNECTS TO POWER SOURCE 10 TO 25 VOLTS
12 VDC - : POWER SOURCE GROUND
INPUT 1 + : TO METER 1 PULSE ENCODER
INPUT 1 - : TO METER 1 PULSE ENCODER
INPUT 2 + : TO METER 2 PULSE ENCODER
INPUT 2 - : TO METER 2 PULSE ENCODER
INPUT 3 + : TO METER 3 PULSE ENCODER
INPUT 3 - : TO METER 3 PULSE ENCODER
INPUT 4 + : TO METER 4 PULSE ENCODER
INPUT 4 - : TO METER 4 PULSE ENCODER
R1 COM : RELAY 1 COMMON
R1 N/O : RELAY 1 NORMALLY OPEN
R1 N/C : RELAY 1 NORMALLY CLOSED
GND
12 V
PTT
RXA
QU3
QU5
IC8
PROGRAMMING
ENCODER 1-R
ENCODER 1-G
ENCODER 1-B
ENCODER 2-R
ENCODER 2-G
ENCODER 2-B
T2
T1
12 VDC +
12 VDC -
INPUT 1 +
INPUT 1 -
INPUT 2 +
INPUT 2 -
INPUT 3 +
INPUT 3 -
INPUT 4 +
INPUT 4 -
R1 COM
R1 N/O
R1 N/C
R2 COM
R2 N/O
R2 N/C
R3 COM
R3 N/O
R3 N/C
CON1
R-CABLE10 P
1
STATUS
QU2
MX42 9AIC3
K3K2K1IC1
INTERNET ENERGY SYSTEMS
C3IWIRELESS GATEW AY
COPYRIGHT 200 4 INTERNET ENERGY SYSTEMS
R2 COM : RELAY 2 COMMON
R2 N/O : RELAY 2 NORMALLY OPEN
R2 N/C : RELAY 2 NORMALLY CLOSED
R3 COM : RELAY 3 COMMON
R3 N/O : RELAY 3 NORMALLY OPEN
R3 N/C : RELAY 3 NORMALLY CLOSED
WARNING: This device may only be installed and serviced by authorized utility
personnel. Access to consumers should be denied with an appropriate utility lock
or seal.
NOTICE: This equipment complies with the FCC RF Exposure Limits. A
minimum of 20 centimeters (8 inches) separation between the device and the
user and all other persons should be maintained.
This device complies with part 15 of the FCC Rules. Operation is subject to
the condition that this device does not cause harmful interference.
SPECIFICATIONS
FREQUENCY COVERAGE
154.390, 154.45625, 154.46375, 154.47125, 154.47875, 173.20375, 173.21, 173.2375,
173.2625, 173.2875, 173.3125, 173.3375, 173.3625, 173.39, 173.39625
INPUT VOLTAGE
MIN 10V
MAX 25V
MAX CURRENT DRAW
300MA
PULSE INPUT VOLTAGE
MIN 2.5V
MAX 20V
APPROXIMATE CPU EPROM WRITE LIFE
10 YEARS
RECEIVER
IF FREQUENCY
SINGLE CONVERSION 455KHZ
SENSITIVITY
12DB SINAD @ 1.4UV
TRANSMITTER
OUTPUT POWER
90MW
DEVIATION
+- 2.5KC MAX
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Internet Energy Systems C3I-W Installation guide

Brand
Internet Energy Systems
Model
C3I-W
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents