2. Howdens
  3. WOK2997

Howdens WOK2997, WOH0980, WOK2897 Operating instructions

  • Hello! I've analyzed the user guide for the Howdens Backboard WOKLE97. This document provides specific instructions on how to properly cut, position, and align the backboard panels, focusing on achieving a seamless look. The guide emphasizes the importance of the panel's orientation and cutting along grout lines. I'm ready to answer your questions about this product.
  • Can the panel be reversed?
    Where should I cut when fitting two backboard sections?
    How do I orient the panel when fitting?
Tile Effect Backboards
Cutting & Positioning Guide
WOKLE97
HD021121
Product
Cutting
This leaflet gives information on how to cut and position the backboard correctly and ensure correct alignment when fitting
one backboard on top of another. Please note: The panel is not reversible.
When fitting two sections together, cut along the very bottom of the grout line of the section you wish to keep,
so it can join seamlessly to the panel below.
Fitting
Ensure the sticker is towards the bottom left
side as shown below.
Note: When joined together, the backboards should have
a seamless look.
Secure to the wall using suitable adhesive.
2440mm
Section of panel to use.
This will form the top part of the
adjoining backboards.
grout line
Important: The cut panel should be kept in the same orientation,
datumed to the bottom left corner.
No grout
line
600mm
Cut along base
grout line
Set panel with this corner
bottom left
QR code
Scan the QR code
using your smart
device to access
the installation
leaflet
WOKLE97HD021101
Set panel with this corner
bottom left
QR code
Scan the QR code
using your smart
device to access
the installation
leaflet
WOKLE97HD021101
Set panel with this corner
bottom left
QR code
Scan the QR code
using your smart
device to access
the installation
leaflet
WOKLE97HD021101
Set panel with this corner
bottom left
QR code
Scan the QR code
using your smart
device to access
the installation
leaflet
WOKLE97HD021101
/