POLE MOUNT FLUORESCENT FIXTURE
INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them
at a later date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture, in order to
prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and National Electrical
Code (N.E.C.) standards. If you are unfamiliar with proper electrical wiring
connections obtain the services of a qualified electrician.
Remove the fixture and the mounting package from the box and make sure that no parts
are missing by referencing the illustrations on the installation instructions.
ASSEMBLY AND INSTALLATION
1. Pull the power supply wires out from the POLE (1). Attach the BLACK SUPPLY WIRE (3) to the
BLACK FIXTURE WIRE (6) and the WHITE SUPPLY WIRE (2) to the WHITE FIXTURE
WIRE (5) using WIRE NUTS (8) (provided). Connect the FIXTURE GROUND WIRE(7) to the
POWER SUPPLY GROUND WIRE(4) using a WIRE NUT(8) (not included). Tuck wires into the
POLE (1).
2. Place YOKE (9) onto the POLE (1) and secure with SCREW (16).
3. Install LISTED COMPACT FLUORESCENT LAMP (17) of correct wattage (see fixture label)
by inserting and then twisting until locked into the SOCKET (18).
4. Place COVER (11) over NIPPLE (15) above the HOUSING (10) and secure with WASHER (14)
and NUT (13). Add FINIAL (12) last.
5. Restore power at circuit breaker.
6. The PHOTOCONTROL(not shown) in this fixture is designed to turn on fix-ture light at low light
levels.during daylight installation light should come on for 1-4min.and then go off.
INSTALLATION IS NOW COMPLETED
1. POLE
2. WHITE SUPPLY WIRE
3. BLACK SUPPLY WIRE
4. SUPPLY GROUND WIRE
5. WHITE FIXTURE WIRE
6. BLACK FIXTURE WIRE
7. FIXTURE GROUND WIRE
8. WIRE NUT
9. YOKE
10. HOUSING
11. COVER
12. FINIAL
13. NUT
14. WASHER
15. NIPPLE
16. SCREW
17. COMPACT FLUORESCENT LAMP
18. SOCKET
FIG. 1