2. Eurotech
  3. WO450

Eurotech WO450 User manual

  • Hello! I've reviewed the installation instructions for the Leo Pendant models WO450, WH450, WO600, and WH600. This document provides detailed steps for installation and safety, emphasizing the requirement for a qualified electrician. The pendants feature a E27 60W max lamp, are constructed from plywood and fabric cord, and have a 2M suspension cable. I am ready to answer any questions you have about these products.
  • Who should perform the installation?
    What type of lamp is required?
    What materials is the pendant made of?
    What is the length of the suspension cable?
Leo Pendant
Model: WO & WH
Installation Instructions
All installations must be carried out by a qualified electrician following local regulations. Make sure that the power is switched off before
installation. Please read and follow the ‘Installation instructions’ and ‘Safety instructions’ sections carefully before commencing installation.
Installation of this model can change from time to time please read instructions every time before installation. For detailed specification, please go to our website eurotechlighting.co.nz
Code: Colour: Dimensions
(mm): Driver: Fixing Area
(mm): Lamp: Material: Suspension
Cable:
WO450 Natural Wood
450Ø x 280H
Driver not
required 120Ø E27 60W max Plywood + Fabric
Cord 2M
WH450 Natural Wood & White
WO600 Natural Wood
600Ø x 380H
WH600 Natural Wood & White
Saftey Instructions
Read these instructions carefully before commencing installation.
1. The light source contained in this luminaire shall only be replaced by the manufacturer or this service agent or a similar qualified person.
2. This LED luminaire must be installed by a licensed electrician ONLY following all local regulations.
3. Ensure that the cables will not be squeezed or damaged by sharp edges.
4. Clean the light with a soft cloth.
5. Misuse of/or changes to the appliance shall void all warranties.
For detailed specification, please go to our website eurotechlighting.co.nz
Installation Instructions
1. Using mounting brackets as a guide drill two mounting holes. Knock two white expansion tubes provided into the holes.
2. Turn two pieces screws into the white expansion tubes through the bracket holes to fix the bracket on the ceiling.
3. Connect wires into connector block provided paying attention to live, natural + earth markings.
4. Once all wires are connected, place your LED lamp into fitting. Ensure installation is correct before switching on the fitting to test.
1
2
3
4
/