Stinger SPXWPRFCD Owner's manual

Stinger
Brand
Stinger
Model
SPXWPRFCD
Type
Owner's manual

This manual is also suitable for

SPXWPBTCD
SPXWPRFCD
86
85
30
87
87a
12V+
3
AMP
FUSE
3
AMP
FUSE
1. Mount the whip base in desired location.
2. Connect extension wire to the Red and
Black wires and route wiring to the battery or
switch / relay location.
3. Refer to diagrams for wiring.
Diagram 1: Wiring direct to power and using
remote control to turn on/off. Must add 3
AMP fuse on RED 12V+ wire.
Diagram 2: Wiring with a switch. You can
add a new dedicated switch or use an
existing light switch that outputs 12V+ when
ON. You will need to add a 3 AMP fuse on
the RED 12V+ wire and also requires a 12V
relay.
Inline Fuse Holder (SPXATC16 or similiar)
3 Amp Fuse
2 Strand Primary Wire
Wire Connectors / Solder
Wire Cover
Zip-Ties
Optional:
Switch
Relay
Diagram 1
Diagram 2
DYNAMIC RGB CONTROLLER
Before you start, read directions completely.
If your vehicle is not pre-wired for external lighting,
you may need the following:
ON
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
The SPX Dynamic Controllers are designed to
work with Stinger SPXWPRGB4D Dynamic Whips
which are sold seperately
SPXWPBTCD
SPXWPRFCD
SPXWPBTCD
SPXWPRFCD
SPXWPBTCD
Stinger is a Power Brand of AAMP Global
15500 Lightwave, Clearwater, Florida 33760
P: 888-228-5560
support@stingerelectronics.com
www.stingerelectronics.com
© 2019 AAMP Global
Group
Device List
Power Button
User Guide
Happy Lighting App
Bluetooth Dynamic RGB Controller
Once the whip is installed as per the SPXWPRGB4D instructions, install the app.
SPXWPRFCD
RF Dynamic RGB Controller
Once the whip is installed as per the SPXWPRGB4D instructions, remove the clear
plastic battery shield from the remote.
Power ON
Play / Pause
Power OFF
Solid Color
Selection
Adjust Speed
[10 Levels]
Adjust Brightness
[32 Levels]
Adjust Mode
[64 Levels]
Auto Mode
GET THE APP
For Apple & Android, scan the QR Code, or visit
https://stingerelectronics.com/hl-app to down-
load the Happy Lighting app. Once the app is
installed, power up the RGB Module and open
the app. The module should auto-connect and
be listed in the Group Device List.
  • Page 1 1
  • Page 2 2

Stinger SPXWPRFCD Owner's manual

Stinger
Brand
Stinger
Model
SPXWPRFCD
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents