The Extron FMR 206 is a 2U rack frame
that mounts in a standard 19-inch
equipment rack, and holds up to six
full-size Flex55 modules.
© 2017 Extron Electronics — All rights reserved. All trademarks mentioned are the property of their respective owners. www.extron.com
68-3166-50 Rev. A
07 17
NOTE: Some modules are difcult to
remove once installed. Make sure the
wiring is correct before snapping in
each module.
Follow these steps to remove an installed Flex55 module.
Flex55 Module Removal
USB STORAGE
MARK
Extron
Extron
RECORD
Secure the FMR 206
to the rack using the
provided #10-32 screws.
1
Connect cables to the Flex55 modules and
snap the modules into the FMR 206.
2
FMR 206 Installation Guide
Extron
Extron
Remove the
module.
Locking
Tabs (2)
Locate the locking tabs and
insert the removal tool up to
the arrow.
Removal Tool
Pull the removal tool
outwards to unhook each
locking tab from the bracket.
Locking
Tab (1)
For modules with one locking tab,
unhook the tab located at the center.
For half modules, the tab is located as
shown below:
Locking
Tab (1)
Extron
Extron
VOLUME
DISPLAY
OFF
ON
PC
Extron
Extron
Extron
Extron
Extron
Extron
1 2 3
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Extron Blank Plate – Half Size Owner's manual
-
-
-
Extron electronics MLM 84 Flex55 User manual
-
Extron Hideaway HSA 402 User guide
-
Extron electronics EBP VC1 EU User manual
-
-
Extron electronics RCP 101 Series User manual
-
Extron electronics DTP T EU 4K 331 User manual
-
Extron electronics ECM DIO8 User manual
