www.aleratec.com
3
Using the HDD Copy Dock
Duplicating Hard Drives
1. UsetheincludedpoweradapterandcordtoplugtheHDDCopyDockintoapower
outlet.
2. InserttheSATAHardDriveyouwanttocopyintotheslotmarked“SOURCE”.
Wheninserting,aligntheSATAportontheHardDrivewiththeSATAconnectorin
thedrivebayslot.
3. InsertthedestinationSATAHardDriveintotheslotmarked“TARGET”.When
inserting,aligntheSATAportontheHardDrivewiththeSATAconnectorinthe
drivebayslot.
Note: Make sure the target Hard Drive has the same or higher capacity than
your source Hard Drive. The duplication process will not start if the target
drive has a lower capacity. Also make sure the unit is not connected to a PC
through the USB port.
4. PowerontheHDDCopyDock.
5. PressandholdtheMODEbuttonfor3secondstochangetheduplicatorsModeto
CopyMode.
6. PressandholdtheCopybuttonfor5secondsandrelease.Theunitwillemitalong
beep.Therststatusbarindicatorlightwillbeginashingwhenthecloneprocess
starts.
Note: Starting the copy process will also erase all data on the target drive.
7. Theduplicationprocessiscompletewhenthestatusbarreaches100%andstops
blinking.
8. PowerofftheHDDCopyDocktoremovetheharddrives.