Assa Abloy EMTEK A User manual

Type
User manual
DOOR
DOOR
HOLE PREPARATION
DOOR
DOOR
IN4-MORTISE-R 15C
Installation Guide - F13 Mortise Lock
Plates and grip vary depending on style.
IN4-MORTISEINSTF13 REV 15A
Assemble to
bottom tube
See template for door prep
2. Install Mortise Lock 1. Install Cylinder Plug
Outside Inside
3. Mount Inside and Outside Trim to Door
Install key 3/4 of the way into
the key cylinder and thread
it clockwise onto trim plate.
Install cylinder plug by
threading it clockwise
onto lock body
4. Install Key Cylinder
After key cylinder is installed,
secure cylinder by tightening
screw
6. Install Trim Plate
Tighten Lever with 3/32
Hex wrench (provided).
See template for door
2. Pull out and rotate
Latch bolt to reverse
its direction.
1. Remove dowel
screw. (Replace
after reversing
swing)
Note: Notch on cylinder
plug must be in the 9
o clock position when
fully screwed onto lock
body.
Installation Guide - F20 Mortise Lock
Plates and grip vary depending on style.
IN4-MORTISEINSTF20 REV 15A
Assemble to
bottom tube
See template for door prep
2. Install Mortise Lock 1. Install Cylinder Plug
Outside Inside
3. Mount Inside and Outside Trim to Door
Install key 3/4 of the way into
the key cylinder and thread
it clockwise onto trim plate.
Install cylinder plug by
threading it clockwise
onto lock body
4. Install Key Cylinder
After key cylinder is installed,
secure cylinder by tightening
screw
6. Install Trim Plate
Tighten Lever with 3/32
Hex wrench (provided).
See template for door
Thumb press
Locked
Thumb press
Unlocked
In
In
2. Pull out and rotate
Latch bolt to reverse
its direction.
1. Remove dowel
screw. (Replace
after reversing
swing)
Note: Notch on cylinder
plug must be in the 9
o clock position when
fully screwed onto lock
body.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Assa Abloy EMTEK A User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI