4 5
INSTRUCTIONS FOR USE
Power source
Please use the supplied micro USB charge cable to connect the Classic DAB to power. This will also
charge your Classic DAB.
Getting started
1. Plug the micro USB charge cable into the Micro USB charge port (17)and connect the USB
to a power supply
2. The LCD display (10) will light up and the Classic DAB will automatically enter standby mode
General operation
• Short press power (13) and the Classic DAB will turn on and enter DAB mode
• Short press power (13) and the Classic DAB will return to standby mode and show the time
and battery indication
• While in standby mode the LCD display (10) backlight will be dimmed
• In any mode, to change the volume short press Volume+ (11) or Volume– (12)
Listening to DAB broadcast
• Fully extend the Antenna (19)
• Click Mode (5) until you reach DAB on the LCD display (10)
• The Classic DAB will automatically search for a station
• Once scan is complete the Classic DAB will select the rst station on the list and will automatically
set the time and date
• To change station short press Previous (7) or Next (8) and leave on your required station
• If no stations are detected the LCD display (10) will read ‘Not Available’
Note: Try another area if no station is found.
Manual Tune in DAB
When on DAB mode, you can manually rescan the area you’re in by simply short pressing Scan (6).
Listening to FM broadcast
• Fully extend the Antenna (19)
• Click Mode (5) until you reach FM on the LCD display (10)
• Short / long press Previous (7) or Next (8) to nd your desired station
• Short press Scan (6) to nd the nearest station with signal and the classic DAB will auto select