OPERATION DESCRIPTION
Temperature adjustment is made with pushbutton (item
5).
Temperature setpoint is done for both compartments at
one time – fridge and freezer.
At first plug-in of appliance factory setpoint is chosen –
medium position (item 3).
Following table shows
set-points level
Description:
LED OFF
LED ON
GUIDE TO SELECTING FUNCTIONS
Temperature selection pushbutton (item 5) is used to
set desired temperature level, from coldest to
warmest . At each short pressure of
the pushbutton, the setpoint will change
(cyclically).
Fast Cooling function
The use of this function is
recommended when placing a very high quantity of
food in the refrigerator compartment.
By pressing and hold the button (item 5) for 3 sec. it is
possible to increase the cooling speed of the foods
inside the refrigerator compartment. The yellow LED
(item 1) will come on. The function is automatically
deactivated after 6 hours.
The "Fast cooling" function can be manually deactivated
by pressing and hold the same button (item 5) for 3 sec.,
the yellow LED (item1) is off.
Note:
- Fast Cooling function should be also switched ON
before placing fresh food to be frozen in the freezer
compartment.
- Fast Cooling function has to be engaged in order to
maximize freezing capacity, thus it has to be engaged
before to add light load.
ABNORMAL APPLIANCE OPERATION
When the product is plugged in to the mains, during
first 10 minutes of its performance, possible temperature
sensor failure will be displayed according to following
table:
Description:
LED OFF
LED Flashing
The appliance will work preserving the food stored, but
it is necessary to contact after-sales service and provide
alarm code.
Note: in case of power failure, appliance goes back to
normal operation and previously chosen setpoint is
restored.
DEFROSTING THE FREEZER COMPARTMENT
No Frost freezers provide chilled air circulation around
the storage areas and prevent the formation of ice,
thereby completely eliminating the need for defrosting.
Frozen items don't stick to the walls, labeling stays
legible and storage space remains neat and clear.
DEFROSTING THE REFRIGERATOR COMPARTMENT
Refrigerator compartment defrosting is completely
automatic.
Droplets of water on the rear wall inside the refrigerator
compartment indicate that the automatic defrost phase
is in progress. The defrost water is automatically run
into a drain hole and collected in a container, where it
evaporates.
REPLACING THE LIGHT BULB
Always disconnect the refrigerator from the power
supply before replacing any light bulb.
If the inside light is not working, it is necessary to:
1. Remove the light cover: move it upwards as shown in
figure.
2. Check the bulb. If
necessary unscrew the
broken bulb and replace
it with the new one.
3. Put on the light cover.
Do not leave the bulb
uncovered.
CA
UKR
ROBGRUSHSKCZPLFINDKNSGRIPENLFGBD
PRODUCT SHEET
GB
R
efrigerator
evaporator sensor
failure
Refrigerator sensor
f
ailure
Refrigerator
evaporator &
r
efrigerator sensor
failure
400010849294 Printed in Italy 11/15