Page is loading ...
1of3
LightSourceToolsRequired
BULB BASE TYPE
Medium (E26)
BULB SHAPE
TYPE A
100W
MAX
2BULBSREQUIRED
BULBSNOTINCLUDED
Warnings and Cautions
Turn off the electricity at the circuit breaker before installation.
Consult a licensed electrician if in doubt about installation.
Turn off power to the fixture and allow the bulbs to cool before
replacing.
Package Contents
Preparation: Identify and inspect all parts
before beginning the installation.
Missing or damaged parts? Contact your
original place of purchase.
Fixture Body
x1
F
Crossbar Assembly Wiring Bulb&Shade
Table of
Contents
STEP 2 STEP 3 STEP 5
Fixture Body
STEP 4
Alternate
Mounting Screw
STEP 1
Shade
x2
E
Crossbar
Assembly
x1
A
PARTS BAG
Alternate
Mounting Screw
x2
B
Outlet Box Screw
x2
C
Wire Connector
x3
D
Installation Instructions: UQL3502
www.urbanambiance.com
STEP 1
OPTION 1 OPTION 2
Included
(Pre-assembled)
Included
Standard
Mounting
Screw
Alternate
Mounting
Screw
skip to next page
1 2 3
Steps 1-3 to remove standard mounting screws
56
Steps 4-6 to reassemble with alternate mounting screws
4
STEP 2
1 2 3
Step 1
Install crossbar assembly
Step2-3
Test fitting backplate to mounting screws
2of3
*Green Ground Screw
on crossbar optional
White wire (neutral)
from outlet box
White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
STEP 3
Black or Red wire (hot)
from outlet box
Bare or Green ground wire
from outlet box
www.urbanambiance.com
STEP 4
3of3
STEP 5
www.urbanambiance.com
/
