2. Oatey
  3. Dearborn1-1
Dearborn1-1

Oatey Dearborn1-1, HDC9100T Installation guide

  • Hello! I've reviewed the instruction guide for the Disposal End Outlet Waste system. This document provides detailed steps on how to assemble and connect the various components, including the flanged tailpiece, washers, nuts, tee, and bracket. I understand that the guide also emphasizes checking for leaks after assembly. If you have any questions about the instructions or the process feel free to ask.
  • What is the first step in assembling the waste system?
    What should I do after attaching the bracket?
    Where is the rubber washer placed?
INSTRUCTION GUIDE
Oatey.com
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specification limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
DISPOSAL END OUTLET WASTE
A
B
C
E
F
D
G
H
I
2
3
4
6
5
1Place nut and flanged washer (A) on flanged tailpiece (B). Thread
nut onto basket strainer.
Place nut (C) and washer (D) on flanged tailpiece (B) and thread
onto tee (E).
Insert rubber washer (F) into flanged tailpiece (G) so flange is
inside groove of washer (F).
Place bracket nut (H) and washer (I) onto flange tailpiece (G) and insert tailpiece (G) into tee (E) Tighten nut (H) to tee (E).
Tighten nuts. CHECK FOR LEAKS.
Attach bracket to disposal with bolts.
/