2. Dearborn Brass
  3. HDC9684

Dearborn Brass HDC9684 Installation guide

  • Hello! I have reviewed the user guide for the 45° Slip Joint Elbow. This document provides instructions on how to properly assemble the slip joint elbow, including measuring and cutting drains, securing with nuts and washers, and checking for leaks. I'm ready to answer your questions about the installation process.
  • What is the first step in assembling the 45° slip joint elbow?
    What components need to be positioned on the drains?
    What should be done after tightening the nuts?
2
3
4
1
Tighten all nuts (A). CHECK FOR LEAKS.
INSTRUCTION GUIDE
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com
Attach drains (D) into 45° (C) while making sure they are fully
inside the sockets.
Position nut (A) then washer (B) on both drains (D).
Measure and cut both drains (D) to required length (They should be
cut to a length that allows them to stop fully inside the 45° (C) socket).
45° SLIP JOINT ELBOW
/