2. Oatey
  3. S-Trap

Oatey S-Trap, HDC2718-1, HDC720-1 Installation guide

  • I have reviewed the instruction guide for the S-Trap. The document provides a clear, step-by-step guide for assembly, featuring identified parts and a recommendation to check for leaks. I'm ready to answer any questions you have about the device and its installation.
  • What do I need to slide on the tailpiece first?
    What do you do with the J-bend?
    What is the last step after attaching the floor tube and sink trap?
4
1
INSTRUCTION GUIDE
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com
3
Slide flange (F) on end of floor tube (D).
Tighten nuts. CHECK FOR LEAKS.
2
Measure and cut floor tube (D) to length. Floor tube (D) should go
into fitting 1 in. minimum.
5
6
Attach floor tube (D) and sink trap (H) to J-bend (C) using washer (B) and by tightening nut (E).
Slide J-bend (C) onto tailpiece and tighten nut (A).
Slide nut (A) and washer (B) on tailpiece.
S-TRAP
/