2. Dearborn Brass
  3. HDC1046-1

Dearborn Brass HDC1046-1 Installation guide

  • Hello! I'm a chat assistant and I've reviewed the provided user guide for the Trap Offset. This document outlines the steps for installing the Trap Offset, involving cutting and connecting drains, positioning nuts and washers, and ensuring a leak-free setup. I'm ready to answer your questions about the device and its installation process.
  • What is the first step in installing the Trap Offset?
    What should be positioned on the connecting drains before attaching them to the Trap Offset?
    After attaching the drains and tightening the nuts, what should you check for?
2
3
4
1
Position nut (A) then washer (B) on connecting drains (D).
Attach top drain (D) into top of Trap Offset (C) and then insert the
bottom drain (D). (Both drains (D) should be cut to a length that
allows them to set fully inside the sockets.)
INSTRUCTION GUIDE
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specification limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com
Tighten all nuts (A). CHECK FOR LEAKS.
Measure and cut drains (D) connecting into Trap Offset (C) to
required length.
TRAP OFFSET
/