BLOTZ B06-RW-001 Assembly Instructions

Brand
BLOTZ
Model
B06-RW-001
Type
Assembly Instructions

This manual is also suitable for

6mm Railways
B06-RW-xxx
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care
and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
All the track bed sections have the position of the
tracks etched into them.
Straight sections also have holes cut for lugs on
the tracks to slot into.
For straight track, take the track sections (bottom of
pic) and slot them into place on the track bed using
the holes to align them (top pic)
For any other pieces (curves, turnouts,
crossovers, etc) they are supplied with “tabs”
between the rails which keep the rails the right
distance apart.
Glue the rails to the track bed (using the etched
guides to position them correctly) then once dry
carefully remove the tabs with a sharp blade.
  • Page 1 1

BLOTZ B06-RW-001 Assembly Instructions

Brand
BLOTZ
Model
B06-RW-001
Type
Assembly Instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents