2. Kentrol
  3. 30722

Kentrol 30722, 50722 Installation guide

  • Hello! I've reviewed the installation instructions for the KENTROL CB Antenna Mount for the Jeep JK Wrangler. This document provides step-by-step directions for mounting your CB antenna. I can help you with any questions you might have about these instructions or the installation process.
  • What tools are required for installation?
    What hardware is included with the mount?
    Where should the existing bolts be stored?
KEN30722
Jeep® JK Wrangler
CB Antenna Mount
KEN3072200
REQUIRED TOOLS
13mm Socket or Wrench
Ratchet
KIT CONTAINS
CB Antenna Mount
M8 x 1.25 x 40mm SS Hex Bolt
M8 SS Washer
M8 SS Lock Washer
QTY
1
2
2
2
KEN30722
Jeep® JK Wrangler
CB Antenna Mount
1 KEN3072200
1) INSTALL
Whether you have an aftermarket backside or
factory tire carrier, with a 13mm socket or wrench.
Remove the 2 top right bolts, and put them away
for future use.
With the mount in hand turn and place the two
beveled bolt holes up to the tailgate holes. Using
the included hardware and a 13mm socket or
wrench, secure the mount into your tailgate. Be
sure to not over tighten as it may damage your
body.
2) CB ANTENNA INSTALL
Install your CB antenna into the mount according to
the manufacturer’s instructions.
ENJOY YOUR NEW KENTROL CB ANTENNA
MOUNT!!!
/