2. Phoenix Gold
  3. ZDAPMB1
ZDAPMB1

Phoenix Gold ZDAPMB1 User manual

  • Hello! I am an AI chatbot trained to assist you with the Phoenix Gold ZDAPMB1 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What kind of vehicle is the Phoenix Gold ZDAPMB1 compatible with?
    What tools are required for stereo removal?
    Which wires need to be connected from the quadlock connector?
    How do you remove the center panel for cable laying?
    Where is the 12V outlet connector located?
    How do you remove the side panel?
    How do you connect the ZDAISOT cable to the CT10MC02?
    Where do you pull the carpet up to insert the cable?
    How do you remove the passenger seat?
    Finally, where is the amplifier installed?
ZDAPMB1
•2021
•W447 (Facelift)
•Audio 30
Mercedes Vito
Use a plastic pry tool on the outer
edges of the plastic panel to
loosen the clips all around. (The
whole panel comes of in one piece)
Stereo Removal 1
Tools required:
•Torx T25 bit
Loosen the four screws marked
with red circles. Then the stereo is
loose and ready to be taken out.
Remove all connectors on the back
of the stereo.
Stereo Removal 2
Remove the black and white
connectors on the back of the
quadlock connector.
Cable Installation 1
Connect the black and white
connectors to the CT10MC02
quadlock connector.
Cable Installation 2
Tools required:
•Plastic pry tool
Use a plastic pry tool to remove
the center panel for easier cable
laying.
Cable Installation 3
Tools required:
•Torx T25 Bit
1. Remove the lower center panel.
On each side there is a plastic
lid, remove both of them and
loosen the T25 screw hidden
behind.
2. Pull the panel towards you from
the center to loosen the panel.
Cable Installation 4
•Loosen the 12V outlet connector
by pulling it upwards.
Cable Installation 5
•Remove the side panel by pulling
in the direction of the arrows.
Cable Installation 6
•Remove the plastic trim panel for
the battery.
Cable Installation 7
•Pull the side panel uppwards to
remove it.
Cable Installation 8
•Connect the ZDAISOT cable to
the CT10MC02 and pull the
cable down to the floor.
•OBS! Use the external 10ohm
resistor cable on the speaker
side.
Cable Installation 9
1. Pull the carpet up so that you
can pull the cable in the center
under the carpet.
2. Remove the passanger seat by
pulling it straight up.
OBS! In some cases this may
require extreme force.
Cable Installation 10
Pull up the cable at the back.
Cable Installation 11
Install the amplifier at the back
under the seat.
Amplifier 1
Screw the amplifier into place and
connect the ZDAISOT connector
cable.
Then put all the panels back in
reverse order.
Amplifier 2
The installation is now complete.
Now connect the USB cable to a
PC/MAC and download our file at
(någon hemsida) to get the best
result!
Happy listening.
Installation Complete
/