2. QOLSYS
  3. QZ8100-840

QOLSYS QZ8100-840 Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the QOLSYS QZ8100-840 Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
IMAGE SENSOR QUICK INSTALL GUIDE
X
✓
Avoid placement
near ceiling fans
Corners above
doors are great
locations
✓
Corners pointed
away from windows
are great locations
X
Avoid
HVAC
ducts
X
✓
Install at least
7.5’ (2.3m)
high
STEP
1
CHOOSE
INSTALLATION
LOCATION
CHOOSE
MOUNTING
ANGLE
ATTACH
BACK
MOUNT
REPLACE
BACK
COVER
Qolsys Inc. proprietary. Reproduction without permission is not permitted. This document references the Image Sensor manufactured by Alarm.com Document last revised 03/22/17
CONTACT TECH SUPPORT
SUPPORT
STEP
2
STEP
3
STEP
4
STEP
5
STEP
8
CHOOSE LOCATION WHERE BOTH MOTION
SENSOR AND CAMERA CAN BE EFFECTIVE
Slide back cover of the casing
downward and remove from device
Choose mounting type based
on height and distance.
8ft (2.4M) or 6ft (1.8M)
Align mount on back and secure with provided hardware
Align back cover and
slide upward to secure
on device
CHOOSE
POST
MOUNT
STEP
6
CORNER
FLAT
MOUNT
IMAGE
SENSOR
STEP
7
SLIDE
DEVICE
ONTO POST
AT DESIRED
ANGLE
INSERT PEG TO
SECURE IN
PLACE
SEND
TEST
IMAGE
STEP
9
LEARN
INTO
PANEL
&
GOT QUESTIONS?
Tech[email protected]om
Place your panel in
“autolearn" mode
Customize name and settings
as desired and and touch “ADD”
ADD
Insert batteries to place
device in “learn” mode
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.
FCC ID: YL6-143IS221
IC: 9111A-143IS221
/