Native Instruments Guitar Rig Session Installation guide

Brand: Native Instruments

Model: Guitar Rig Session

Type: Installation guide

Native Instruments Guitar Rig Session is a versatile audio interface and guitar amp simulator that allows you to connect your guitar or bass, microphone, and speakers to your computer, providing you with a wide range of guitar tones and effects. With its intuitive software interface, you can easily create and customize your own unique sounds. Whether you're a beginner or a seasoned pro, Guitar Rig Session is the perfect tool for recording, practicing, and performing.

Native Instruments Guitar Rig Session is a versatile audio interface and guitar amp simulator that allows you to connect your guitar or bass, microphone, and speakers to your computer, providing you with a wide range of guitar tones and effects. With its intuitive software interface, you can easily create and customize your own unique sounds. Whether you're a beginner or a seasoned pro, Guitar Rig Session is the perfect tool for recording, practicing, and performing.

GUITAR RIG SESSION SETUP GUIDE

Connect your guitar or bass to the in-

strument input 1 of the SESSION I/O

interface. Make sure the Line/Instru-

ment switch is set to Instrument.

To use a microphone, connect it to the

XLR input. Pleas e refe r to the

SESSION I/O manual for more infor-

mation. You will ﬁ nd the manual in the

“Guitar Rig 3” application folder on

your Mac and in the “Session IO” fold-

er on your PC.

Connect your power ampliﬁ er, mixer or

active speakers to the output 1/2 jacks

on the back of the SESSION I/O.

NOTE: Please take notice of the output 1/2

level (volume) settings when doing this!

Start your GUITAR RIG 3 XE software.

In GUITAR RIG 3 XE, go to Audio and

MIDI Settings (PC) or Preferences (Mac

®

).

4

Please use the “Guitar Rig 3” installer to install the GUITAR RIG 3 XE software and the NI USB Audio hardware

driver on your computer. Please connect the SESSION I/O interface to a USB 2.0 socket on your computer when

asked during installation.

Click on SoundCard and select Session

I/O

as the output device. Please make sure

Interface is set to CoreAudio™ (Mac

®

)

and ASIO™ (PC) respectively.

5

Conﬁ rm your selection with a click on OK.

6

Increase the gain for input 1 to get a

proper input signal in the software (the

green LED on top of the interface indi-

cates an incoming signal, the red LED

indicates overload).

7

Load a GUITAR RIG 3 XE preset and

have fun!

8

If you plan to use your guitar amp in conjunction with the SESSION I/O, simply connect

either one of the outputs of the SESSION I/O audio interface to your amp to run a “mono”

setup. To get a true stereo setup, connect both SESSION I/O outputs to your amp.

If you experience ground loops or noise, a DI box between the SESSION I/O and your

amp can help to alleviate this problem. Please check our Knowledge Base for further

info on this topic.

ADDITIONAL NOTES

All product and company names are ™ or ® trademarks of their respective holders. All speciﬁ cations are subject to change without notice.

GUITAR RIG SESSION SETUP GUIDE

1
2

Native Instruments Guitar Rig Session Installation guide

Brand: Native Instruments

Model: Guitar Rig Session

Type: Installation guide

Native Instruments Guitar Rig Session is a versatile audio interface and guitar amp simulator that allows you to connect your guitar or bass, microphone, and speakers to your computer, providing you with a wide range of guitar tones and effects. With its intuitive software interface, you can easily create and customize your own unique sounds. Whether you're a beginner or a seasoned pro, Guitar Rig Session is the perfect tool for recording, practicing, and performing.

Related papers

Other documents