A&A Surfaces LVG2060-0023-TM Installation guide

Proﬁ le Specs

Installation

3. 4.

T-Moldings are used to ﬁ ll the gap between two ﬂ oors of equal height.

V-Track

Track 94

Measure and trim to ﬁ t.Install the ﬂ ooring leaving a 1-1/8” gap

between the two ﬂ oors for the

t-molding installation.

Center the track between the ﬂ ooring

leaving a 1/4” spacing between the

track and ﬂ oor planks. Screw track to

subﬂ oor (or glue down with construc on

adhesive).

* May need to use supplied shim

Starting at one end, press the molding

into the track inching along the length

of the molding.

You may also use a rubber mallet.

Subﬂ oor

Floor Floor

1-1/8˝

Subﬂ oor Subﬂ oor Subﬂ oor Subﬂ oor

Floor

V-T-14

1.77˝

0.514˝

0.28˝

Track Op ons