2. A&A Surfaces
  3. LVR5012-0011-R
LVR5012-0011-R

A&A Surfaces LVR5012-0011-R Installation guide

  • Hello! I am an AI chatbot trained to assist you with the A&A Surfaces LVR5012-0011-R Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Profi le Specs
Installation
1.
3. 4.
2.
Surface reducers are used to fi ll the gap between fl oors of unequal heights.
Measure and trim to fi t.Install the fl ooring leaving a 1” gap
between the two fl oors for the
surface reducer installation.
Center the track between the fl ooring
leaving a 1/4” spacing between the
track and fl oor planks. Screw track to
subfl oor (or glue down with construc on
adhesive).
* May need to use supplied shim
Starting at one end, press the molding
into the track inching along the length
of the molding.
You may also use a rubber mallet.
Subfl oor
Linoleum Tile
Linoleum Tile
Linoleum Tile
1˝
Subfl oor Subfl oor Subfl oor Subfl oor
LVT FloorLVT Floor
LVT Floor
1
/
4
˝
1
/
4
˝
V-SR-14
1.77˝
0.514˝
0.345˝
/