A&A Surfaces LVG2012-0038-EC Installation guide

LVG2012-0038-EC
Brand
A&A Surfaces
Model
LVG2012-0038-EC
Type
Installation guide
Profi le Specs
Installation
1.
3. 4.
2.
End caps are used to fi ll the gap between the fl oor and carpet, hearths or
against sliding doors.
Measure and trim to fi t.Install the fl ooring leaving a 1” gap
between the two fl oors for the
end cap installation.
Center the track between the fl ooring
leaving a 1/4” spacing between the
track and fl oor planks. Screw track to
subfl oor (or glue down with construc on
adhesive).
Starting at one end, press the molding
into the track inching along the length
of the molding.
You may also use a rubber mallet.
Subfl oor
1˝
Subfl oor Subfl oor Subfl oor Subfl oor
LVT FloorLVT Floor
LVT Floor
1
/
4
˝
1
/
4
˝
V-EC-14
1.5˝
0.529˝
0.25˝
  • Page 1 1

A&A Surfaces LVG2012-0038-EC Installation guide

LVG2012-0038-EC
Brand
A&A Surfaces
Model
LVG2012-0038-EC
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents