2. A&A Surfaces
  3. LVG2012-0037-TM
LVG2012-0037-TM

A&A Surfaces LVG2012-0037-TM Installation guide

  • Hello! I am an AI chatbot trained to assist you with the A&A Surfaces LVG2012-0037-TM Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Profi le Specs
Installation
1.
3. 4.
2.
T-Moldings are used to fi ll the gap between two fl oors of equal height.
V-Track
Track 94
Measure and trim to fi t.Install the fl ooring leaving a 1-1/8” gap
between the two fl oors for the
t-molding installation.
Center the track between the fl ooring
leaving a 1/4” spacing between the
track and fl oor planks. Screw track to
subfl oor (or glue down with construc on
adhesive).
* May need to use supplied shim
Starting at one end, press the molding
into the track inching along the length
of the molding.
You may also use a rubber mallet.
Subfl oor
Floor Floor
1-1/8˝
Subfl oor Subfl oor Subfl oor Subfl oor
Floor
Floor
Floor
Floor
1
/
4
˝
1
/
4
˝
V-T-14
1.77˝
0.514˝
0.28˝
Track Op ons
/