A&A Surfaces LVG2012-0030-TM Installation guide

Type
Installation guide
Profi le Specs
Installation
1.
3. 4.
2.
T-Moldings are used to fi ll the gap between two fl oors of equal height.
V-Track
Track 94
Measure and trim to fi t.Install the fl ooring leaving a 1-1/8” gap
between the two fl oors for the
t-molding installation.
Center the track between the fl ooring
leaving a 1/4” spacing between the
track and fl oor planks. Screw track to
subfl oor (or glue down with construc on
adhesive).
* May need to use supplied shim
Starting at one end, press the molding
into the track inching along the length
of the molding.
You may also use a rubber mallet.
Subfl oor
Floor Floor
1-1/8˝
Subfl oor Subfl oor Subfl oor Subfl oor
Floor
Floor
Floor
Floor
1
/
4
˝
1
/
4
˝
V-T-14
1.77˝
0.514˝
0.28˝
Track Op ons
  • Page 1 1

A&A Surfaces LVG2012-0030-TM Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI