Classic Home
House Parts, Inc., P a g e 1 | 2
Installation For 1 3/8” Wood Pole and Drapery Bracket #9326 Pair
House Parts urges you to engage a professional installer.
Start at the Window where the Treatment will be Installed
Brackets should be installed into window frame or studs.
Only light weight fabric drapes should be hung on installations into Drywall using the mollie/anchors
which are included.
Common installations for window treatments are:
1) To make windows appear larger and allow more light into the room, mount
the pole at the top edge of the trim and allow the rod width to extend beyond the actual
width of the window by 3” to 10”.
2) Above the window on the wall
3) On the window frame
4) Inside the window frame
Drapery finials will add approximately 6 inches to the width of the overall installation.
Measuring for the Height of Your Draperies
To determine the vertical height for mounting the brackets, you need to decide if the bottom of the
draperies should fall at the window sill, below the sill, fall to the floor or puddle on the floor.
The top of the draperies should be approximately 4” above the glass so the back of the pleats will not
be visible from outside the window.
Classic Home
House Parts, Inc., P a g e 2 | 2
Determine the Measurements of your Brackets
Three important measurements to know are:
Projection – the distance from the front of the bracket to the wall
Return – the distance from the center of the bracket cup to the wall
Clearance – the distance from the back of the pole to the wall
Pay attention to the Projection and Return measurements of the bracket.
The Return for a standard drapery hardware bracket is 3 ½ inches.
Mounting Plate Bracket
Bracket Hardware for Wood Pole Installation
These brackets come with a plate that mounts to the wall or window frame.
Loosen the screws on the back of the bracket holding the mounting plate and remove the plate.
Tighten the screws on the bracket a bit.
Mark where you want the plate and drill the holes with a 1/8” wood drill bit. Be sure to mount the
plate with the open hole at the top. The screws on the back of the bracket slide into the plate. To
achieve a firm grip, you can adjust of the screws until the bracket tightly fits onto the mounting
plate.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Rod Desyne HCF08-28-7 Installation guide
-
Homestyles 12389 Installation guide
-
Rod Desyne 5707-845D Installation guide
-
Elrene 100154CRDX028X048ANB Installation guide
-
Lutron Electronics Sivoia QED Technical Reference Manual
-
Achim INOOXF6604 Installation guide
-
Rod Desyne CH150-52-86-7 User manual
-
Bali Cut-to-Size 37-7502-93 User guide
-
Utopia Alley D12AB Measurement Guide
-
Rod Desyne 5788-844 Installation guide
