2. ICP
  3. TPD-283

ICP TPD-283, TPD-283U Quick Start

  • Hello! I am an AI chatbot trained to assist you with the ICP TPD-283 Quick Start. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
TPD-280 Series Quick Start, version 1.0.8. Last Revised: February 2011 Page: 1
Copyright © 2011 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [email protected]
TPD-280 Series
Quick Start
Guide
Version 1.0.8
E-mail: servic[email protected]
FTP: ftp://ftp.icpdas.com/pub/cd/touchpad/
Wirings
Data+ and Data- are signal pins in the RS-485 network
VDC/GND are power (+10 ~ 30 VDC) and ground
TPD-280 Series Quick Start, version 1.0.8. Last Revised: February 2011 Page: 2
Copyright © 2011 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [email protected]
Install HMIWorks
Follow the steps to install the
HMIWorks.
Setup Device
Before downloading programs to the
TPD-280, be sure to setup TPD-280 first.
Run HMIWorks_Standard.exe and click on
the menu: Run Setup Device. Simply
choose com port then press OK.
TPD-280 Workflow
TPD-280 Series Quick Start, version 1.0.8. Last Revised: February 2011 Page: 3
Copyright © 2011 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [email protected]
Integrate with I/O modules
In this example, we use TPD-280 to control an I-7066, the
7-channel photo-MOS relay output module of ICP DAS. First, put
I-7066 in the same RS-485 network of TPD-280 and configure
I-7066 with DCON Utility.
0. Configure I-7066 Using DCON Utility
Download DCON Utility and its user manual on
ftp://ftp.icpdas.com/pub/cd/8000cd/napdos/driver/dcon_utility/
Then configure I-7066 with DCON Utility. Mainly, Address(Net ID),
Baudrate, Databit, Parity, Stopbit should be set.
1. Create a New Project
Go to the menu: File New…, and here we choose
programming type as [2] Ladder Program.
2. Register Device
Create a new connection first in the Workspace.
And then press F3 key to evoke the “Devices” window to register
I-7066.
TPD-280 Series Quick Start, version 1.0.8. Last Revised: February 2011 Page: 4
Copyright © 2011 ICP DAS Co., Ltd. All Rights Reserved. E-mail: [email protected]
Then select the picture which represents the tag. Drag and drop
the tag that is corresponding to the DO0 of I-7066 to the frame
design space. On the frame design space, the picture you just
pick is now on the frame.
3. Setup Device
Go to the menu Run Setup Device. Refer to
previous section for details.
4. Compile and Download to Run
After connecting to TouchPAD, press F9 to run (or
Run Run).
As the following figure shows, pressing the button
changes the output of channel 0 of the I-7066.
/