Minicom 1VS22036 Quick Installation Manual
- Category
- Cable splitters or combiners
- Type
- Quick Installation Manual
This manual is also suitable for
The Minicom 1VS22036 Power Remote unit enhances the capabilities of your AVDS Transmitter system by providing better audio signals and the flexibility to use either CAT5 UTP or Shielded CAT5 FTP cables for connections. With a separate power supply, this unit ensures reliable performance and can be situated up to 110m/360ft away from the Transmitter, delivering high-quality audio to remote speakers.
The Minicom 1VS22036 Power Remote unit enhances the capabilities of your AVDS Transmitter system by providing better audio signals and the flexibility to use either CAT5 UTP or Shielded CAT5 FTP cables for connections. With a separate power supply, this unit ensures reliable performance and can be situated up to 110m/360ft away from the Transmitter, delivering high-quality audio to remote speakers.
www.minicom.com
International HQ
Jerusalem, Israel
Tel: + 972 2 535 9666
North American HQ
Linden, NJ, USA
Tel: + 1 908 486 2100
European HQ
Dübendorf, Switzerland
Tel: + 41 44 823 8000
Customer support - support@minicom.com
5UM40123 V1.3 7/08
CAT5 AVDS Transmitter
Quick Installation Guide
AVDS TRANSMITTER
1
1. Introduction
The AVDS Transmitter system from Minicom, broadcasts real-time high-resolution
video and mono audio signals to hundreds of remote display monitors and speakers.
The AVDS Transmitter system consists of the following components:
• Transmitter Unit P/N 1VS22031 + Control Unit
• Line Splitters P/N 1VS22019 to expand the system
• Remote units P/N 1VS23011
• Power Remote units P/N 1VS22036 – for enhanced audio signals
Warning! Do NOT connect units with the above part numbers to units of
earlier AVDS Transmitter systems that have different part numbers. Part
numbers are located on the back of each unit.
2. The 2 types of Remote units
Note! Any reference to Remote units refers to both Remote and Power Remote units
unless stated otherwise
Both types of Remote units can be up to 110m/360ft away from the Transmitter.
The difference between the 2 Remote unit types is as follows:
The Remote units:
• Do not need a separate power supply they receive power from the connected
CAT5 FTP cable
• Must be connected with Shielded CAT5 FTP cables
The Power Remote units:
• Need a separate power supply (provided)
• Can be connected with CAT5 UTP or Shielded CAT5 FTP cables
• Produce better quality audio signals
QUICK INSTALLATION GUIDE
2
3. The multi-functional AVDS Transmitter system
You can use the AVDS Transmitter system in the following ways:
(A) Without the Control Unit
The AVDS Transmitter system constantly broadcasts a computer screen with
audio to all remote monitors/speakers.
(B) With the Control Unit
• Broadcast a computer screen with audio to all remote monitors/speakers
• Darken all remote screens (audio broadcast is unaffected)
• Release the remote screens to allow local monitor viewing (when remote
computers are connected).
The screen dark function is useful when carrying out maintenance, changing
the broadcast program or in a classroom environment to grab students’
attention.
(C) RS232 Serial control
Connect the RS232 cable (illustrated below) and control the system via RS232
Serial control.
Screen resolutions
All the above applications broadcast video up to resolutions of 1600 x 1200 @
75Hz depending on the cable length.
4. The AVDS Transmitter units
The figures below illustrate the Control unit, Transmitter Unit, Line Splitter and the
Remote units.
VDS Control Unit
Master
to all
Dark
all
MINICOM
Control Unit
AVDS TRANSMITTER
3
www.minicom.com
Headset
Input
Line
VIDEO IN
VIDEO OUT
SYSTEM
12VDC
BUTTON
Power
connector Control Unit
System
cable Monitor
Video
cable
Audio cables
Microphone &
speakers
Output
SERIAL
C
O
N
T
R
O
L
Serial
Transmitter Unit
www.minicom.com
SYSTEM IN
12VDC
SYSTEM OUT
System cables
Power
connector
System cable from Transmitter or
previous Line Splitter
Line Splitter
AUDIO
PICTURE
IN
SYSTEM
VIDEO IN
Side A Side B
System
cable Headphones
Monitor
(Optional)
Video
cable
(Optional) to
Sound card
Picture adjuster
Remote unit
QUICK INSTALLATION GUIDE
4
AUDIO
PICTURE
IN
SYSTEM
VIDEO IN
Side A Side B
System
cable Headphones
Monitor
(Optional)
Video
cable
(Optional) to
Sound card
Picture adjuster
6VDC
Power
connector
Power Remote unit
5. Pre-installation instructions
Note! In the AVDS Transmitter system the CAT5 cables carry electrical power.
Therefore do NOT connect them to any other device. To avoid this we recommend
you attach the stickers provided to the ends of each CAT5 cable.
Place cables away from fluorescent lights, air conditioners, and machines that are
likely to generate electrical noise.
6. The AVDS Transmitter cables
The supplied AVDS Transmitter cables are illustrated below.
Transmitter Video cable
To host
computer’s
Video port
To
Transmitter’s
Video In port
Transmitter Audio cable
To host computer’s
Microphone port
To Transmitter’s Sound
Card Microphone port
To host
computer’s
Serial port
To Transmitter’s
Serial port
(Optional) RS232 cable
7. Connecting an optional remote computer
You have the option to connect the Remote units to a computer, which can be
worked on locally. To do so you need to connect Video and Audio cables between
the Remote unit and a computer. You can order Remote Video and Audio cables
from Minicom.
8. Power supply
Connect the Transmitter and Line Splitters to the power supply with 12 VDC, from
the AC/DC adapter provided.
AVDS TRANSMITTER
5
Connect the Power Remotes to the power supply with 6 VDC, from the AC/DC
Power adapter provided.
The Remote units receive 12 VDC, 160 mA via the CAT5 cables from the Line
Splitter.
9. Expanding the AVDS Transmitter system
You can expand the AVDS Transmitter system to 512 Remote units by having up
to 3 levels of Line Splitters. The Line Splitters on levels 1 and 2 can have 8 Remote
units or Line Splitters connected to it. Each Line Splitter on level 3 can connect to 8
Remote units. (See the configuration diagram on page 6).
QUICK INSTALLATION GUIDE
6
10. The AVDS Transmitter configuration for a CBT application
The figure below illustrates the AVDS Transmitter configuration.
Audio
cable
Video cable
Video cable
Transmitter Unit
Transmitter
computer
Optional remote
computer
Line
Splitter
(Optional)
Control Unit
Audio
cable
Video cable
Audio
cable
Video cable
Power/
Remote
Line
Splitter
CAT5 cables to
Remote Dongles
or Line Splitters
Audio cables
CAT5 cable to
Line Splitter
Level 1
Level 2
(Optional)
RS232 cable
CAT5 cables to
Remote units or
Line Splitters
CAT5 cables to
Remote units or
Line Splitters
Power/
Remote
Power/
Remote
Optional remote
computer
Optional remote
computer
AVDS TRANSMITTER
7
11. AVDS Transmitter detailed connections
The figure below illustrates the detailed connections of the AVDS Transmitter
units.
VDS Control Unit
Master
to all
Dark
all
MINICOM
Audio
cable
www.minicom.com
SYSTEM IN
12VDC
SYSTEM OUT
AUDIO
PICTURE
IN
Video cable
Video cable
(Optional)
Control Unit
CAT5 cables to
Remote units or
Line Splitters
Power/
Remote
unit
Line
Splitter
Transmitter
Unit
Transmitter
computer
Optional
Remote
computer
Microphone connector
to pink Audio cable
connector
CAT5 cable to
Line Splitter
CAT5 cables to
Remote units or
Line Splitters
Pink connector to
Microphone port
Orange connector to
speaker port
To Input port
To Mic. port
To Speaker port
Audio cables
To Serial port
To USB port
(Optional) RS232 cable
www.minicom.com
Headset
Input
Line
VIDEO IN
VIDEO OUT
SYSTEM
12VDC
BUTTON
Output
SERIAL
C
O
N
T
R
O
L
To Button port
To
Serial
port
To Output
port
QUICK INSTALLATION GUIDE
8
12. Configuration without remote computers
The figure below illustrates the AVDS Transmitter configuration without optional
computers connected to the Remote units. The connections are the same as above
minus the Remote Video and Audio cables.
Video cable
Transmitter Unit
Transmitter
computer
Line
Splitter
(Optional)
Control Unit
Power/
Remote
Line
Splitter
CAT5 cables to
Remote Dongles
or Line Splitters
Audio cables
CAT5 cable to
Line Splitter
Level 1
Level 2
(Optional)
RS232 cable
CAT5 cables to
Remote units or
Line Splitters
CAT5 cables to
Remote units or
Line Splitters
Power/
Remote
Power/
Remote
AVDS TRANSMITTER
9
13. Operating the AVDS Transmitter system
Operate the AVDS Transmitter system with the Control Unit or RS232 Serial
control.
The Control Unit performs the following functions:
Master to all
Press the Master to all button to send the host computer’s screen with audio to all
remote screens /speakers. The LED above the button lights up.
Press the button again to release the remote screens/speakers, allowing local monitor
viewing (when remote computers are connected).
Dark all
Press the Dark all button to darken all remote screens. The LED above the button
lights up. (Dark all does not affect audio broadcasting).
Press the button again to release the remote screens.
14. Adjusting the picture
When the broadcasted screen needs adjusting, turn the Picture adjuster on the
Remote unit using a small screwdriver.
QUICK INSTALLATION GUIDE
10
15. Technical specifications
SYSTEM
Resolution Up to 1600x1200 @ 75 Hz
System cable Shielded CAT5 FTP 2x4x24 AWG Solid Wire Conductor
cable (+UTP for Power Remote)
Max distance 110m/360ft
Input/Output Video Signals Analog signal red, green, blue 0.7v p-p 75 Ohm
Sync. TTL compatible
Horizontal/Vertical Sync. Polarity Positive/Negative
Audio Mono
Operating Temperature 0ºC to 40ºC/32ºF to 104ºF
Storage Temperature -40ºC to 70ºC/-40ºF to 158ºF
Warranty 3 Years
TRANSMITTER LINE SPLITTER REMOTE
Cables &
Connectors
VGA In - HDD15M
VGA Out - HDD15F
System Out - RJ45
Mic/Headphone/Sc In/Out –
Jack
Controller - MiniDin8F
Power jack
System In - RJ45
System Out - RJ45
Power jack
System In - RJ45
CPU VGA - HDD15M
Screen - HDD15F
Audio In/Out – Jack
Power Remote -
Power jack
Dimensions
(HxWxD)
4.2 x 15 x 9.4 cm/
1.6 x 5.9 x 3.7 in
4.2 x 11.8 x 9.6cm/
1.4 x 3.9 x 3.1 in
3.2 x 7.8 x 6.2 cm/
1.3 x 3.1 x 2.4 ”
Power supply AC/DC Power Adapter
12VDC 2A
AC/DC Power Adapter
12VDC 2A
Remote
12 VDC, 160 mA
from Broadcaster or
Line Splitter
Power Remote -
AC/DC Power
Adapter 6VDC 2A
AVDS TRANSMITTER
11
Re
g
ional Offices
Germany
Kiel
Tel: + 49 431 668 7933
France
Vincennes
Tel: + 33 1 49 57 00 00
Italy
Rome
Tel: + 39 06 8209 7902
England
Tel: + 44 121 288 0608
China
Tel: +86 21 6445 3181
Asia Pacific / S. Korea
Tel: +972 2 535 9618
www.minicom.com
2008 © Copyright Minicom Advanced Systems Ltd.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
Minicom 1VS22036 Quick Installation Manual
- Category
- Cable splitters or combiners
- Type
- Quick Installation Manual
- This manual is also suitable for
The Minicom 1VS22036 Power Remote unit enhances the capabilities of your AVDS Transmitter system by providing better audio signals and the flexibility to use either CAT5 UTP or Shielded CAT5 FTP cables for connections. With a separate power supply, this unit ensures reliable performance and can be situated up to 110m/360ft away from the Transmitter, delivering high-quality audio to remote speakers.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Minicom VGA Extender User manual
-
-
Tripp Lite CAT5 Smart KVM Extender User manual
-
-
-
Tripp Lite 0SU52016 Owner's manual
-
Minicom Advanced Systems DX System User manual
-
-
-
Other documents
-
-
-
-
Kramer Electronics VDS-RD Datasheet
-
-
-
-
-
Omega OMA-AVDS-4 Owner's manual
-