Physical Description
SP676A front view
SP684A front view
Please refer to the following table for LED definition
Attention：The Mini GBIC slot shares the same LED indicators
with Gigabit RJ-45 (copper) ports.
3
21
4
Installation
Micronet SP676A/SP684A Gigabit Switch is plug-n-play without any
software to configure and also fully compliant with all kinds of
network protocols.
The switch provides 16/24 RJ-45 ports of 10/100/1000M. Just
connect your stations to it and play. Four mini-GBIC slots are
optional. They are respectively shared with last 4 ports but have
higher priority than the RJ-45 ports. If both RJ-45 ports and
mini-GBIC slot are in use, the system will automatically detect
mini-GBIC slots first. The mini-GBIC slot will be active, and the
RJ-45 port will be disabled and ignored.
All ports could be used to connect with another switch. As all the
ports support auto-uplink (MDI / MDI-X) function, user can choose
to use a straight cable or a crossover cable to make a
switch-to-switch connection.
For cable selection, refer to the following table
Introduction
Micronet SP676A/SP684A Gigabit switch offers practical Ethernet
switching solutions for enterprises and business. The16/24 Gigabit
ports provide the fat pipe to the server or backbone connectivity for
boosting the total system performance and allowing non-blocking
throughput where it needed. Also, it is perfect for graphics,
multimedia, and other applications that have to move large files
across the network quickly. In addition to the cooper ports, one of
the ports supports fiber connection with the equipped Mini-GBIC
ports for obtaining long-distance communication.
All ports support auto-uplink detection, so users don't have to worry
about the cable type. Each port will automatically communicate for
best speed and to run in half- or full-duplex mode.
Store-and-forward switching prevents damaged packets and
network errors from being passed on into the network.
Package content
Before you start installing the device, verify the following items are
in the package:
● SP676A/SP684A Gigabit Switch
● Quick installation guide
● Rack-mount brackets
● Rubber foot and screws
● Power cord
Features
● Compliant with IEEE802.3 10Base-T, IEEE802.3u 100Base-TX,
IEEE802.3ab 1000Base-T, IEEE 802.3z 1000Base-SX/LX and
IEEE802.3x flow control standards
● Provide 16/24 RJ-45 ports of 10/100/1000Mbps and 4 shared
Mini-GBIC slots for fiber extension.
● Support auto-negotiation function to automatically select optimal
speed (10/100/1000M) and mode (full/half duplex)
● Support auto uplink, no more cross-over cable
● Supports back-pressure (half duplex) and flow control (IEEE
802.3x) Wire-speed packet filtering and forwarding rate
● Store-and-forward architecture
● Support jumbo frame up to 9K bytes
● Supports 8K bytes MAC address entries
● Support 340K(16-port)/500K(24-port) bytes buffer Memory
● 19” Rack mountable
LED OperationStatus
POWER
1000M
10/100M
Power is on.
Power is off.
Connection established.
Transmitting or receiving data.
No link or connected at 10M or 100M
Connection established.
Transmitting or receiving data.
No link or connected at 1000M.
On
Off
On/Green
Blink/Green
Off
On/Green
Blink/Green
Off
RJ-45
RJ-45
RJ-45
Connector
Cat. 3, 4, 5 UTP/STP
Cat. 5 UTP/STP
Cat .5,5e UTP/STP
Cable Type
100m
100m
100m
Max.
Length
Network
Speed
10Mbps
100Mbps
1000Mbps
PN: 2300-0448
7
5 6
Quick Installation Guide
EtherFast Gigabit Switch
Model No.: SP676A/SP684A
http://www.micronet.info
Specifications CE Mark Warning
This equipment complies with the requirements relating to
electromagnetic compatibility, EN 55022 class A for ITE, the
essential protection requirement of Council Directive 89/336/EEC
on the approximation of the laws of the Member States relating to
electromagnetic compatibility.
Company has an on-going policy of upgrading its products and it
may be possible that information in this document is not up-to-date.
Please check with your local distributors for the latest information.
No part of this document can be copied or reproduced in any form
without written consent from the company.
Trademarks:
All trade names and trademarks are the properties of their
respective companies.
Copyright © 2006, All Rights Reserved
IEEE802.3 10BASE-T
IEEE802.3u 100BASE-TX
IEEE802.3x full-duplex flow control
IEEE802.3ab 1000BASE-T
IEEE 802.3z 1000Base-SX/LX
16/24 *10/100/1000 Mbps RJ-45 ports
4* Mini-GBIC module slots
RJ-45 (10BASE-T): Cat.3,4,5 UTP/STP
RJ-45 (100BASE-TX): Cat.5 UTP/STP
RJ-45 (1000BASE-T): Cat. 5,5e UTP/STP
Fiber: depend on Mini-GBIC types
(SP676A) 340K bytes Buffer Memory
(SP684A) 500K bytes Buffer Memory
10/100/100 Mbps Auto-negotiation
Auto Uplink (Auto MDI / MDI-X)
Auto negotiation
Support jumbo frame up to 9K bytes
10Mbps: 14,880pps/14,880pps
100Mbps: 148,800pps/148,800pps
1000Mbps: 1,488,100pps
0 ° - 40 ° C (32 ° - 104° F)
10% - 90% (Non-condensing)
130 x 441 x 44.1 mm ( W x L x H )
1.86
100 - 240V AC, 50/60Hz
Full range internal power supply
CE
8K entries
Standard
Interface
Cable Connections
MAC Address
Buffer Memory
Network Speed
Feature
Operating Temperature
Operating Humidity
Dimension (mm)
Weight (kg)
Power Supply
Emission
Filtering/
Forwarding Rate
/
