Legrand Telecom Service Conditioning Module, IS-0204 Installation guide

Brand: Legrand

Model: Telecom Service Conditioning Module, IS-0204

Type: Installation guide

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

Page 1 of 1

INSTRUCTION/INSTALLATION SHEET

TELECOM SERVICE CONDITIONING

MODULE

IS-0204 REV. A

1. Introduction

The On-Q/Legrand Telecom Service Conditioning Module, PN

364599-01, is a mounting plate that accepts up to three

Telecom Service Module Conditioning Units. This module

can be mounted into any On-Q style enclosure and has an

attached wire for grounding to provide a common ground to

the plate and the attached conditioning units. See Figure 1.

2. Description

The Telecom Service Conditioning Module consists of a black

powder coated steel base plate with integral threaded

standoffs for mounting up to three conditioning units and the

48 inch 14 gage grounding cable (supplied). The module is a

half-width module, 4”H x 6.42”W, which is mounted with the

On-Q style tab and plunger arrangement.

3. Installation

A. Mounting the module in enclosure (See Figure 2)

1. Align tabs on module with slots on rail of enclosure.

2. Insert tabs by angling module away from the back of the

enclosure and sliding forward.

3. Rotate the module and insert fasteners on module into

corresponding holes on rail of enclosure. (Plunger must be

in the pulled out position for fastener to engage hole.)

4. Push plunger in to lock module in place. Pull on module to

assure module is locked properly in place.

Note: Recommended location for Service Conditioning

Module is in close proximity to the Telecom Distribution

modules; however, modules may be mounted in any

available space.

B. Grounding Module

1. Route attached ground cable to the enclosure ground lug.

2. Connect ground cable securely to the enclosure ground.

Note: Enclosure must be properly installed and grounded for Surge conditioning units to function.

Figure 1

Figure 2

Legrand Telecom Service Conditioning Module, IS-0204 Installation guide

Legrand Telecom Service Conditioning Module, IS-0204 Installation guide

Legrand Telecom Service Conditioning Module, IS-0204 Installation guide

Related papers

Other documents