Legrand Security Interface Conditioning Unit, IS-0211 Installation guide

Brand: Legrand

Model: Security Interface Conditioning Unit, IS-0211

Type: Installation guide

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

Page 1 of 2

INSTRUCTION/INSTALLATION SHEET

SECURITY INTERFACE CONDITIONING

UNIT

IS-0211 REV. A

1. Introduction

The On-Q/Legrand Security Interface Conditioning Unit, PN

364602-01, provides RJ31X functionality to allow the security

system to seize Line 1 and report an alarm. The other 3 lines

are passed through the unit to distribution. The Security

Interface Conditioning Unit mounts to an On-Q Telecom

Service Conditioning Module, PN 364599-01, which can be

mounted into any On-Q style enclosure. See Figure 1.

2. Description

The Security Interface Conditioning Unit is a red unit with a

captive mounting screw, for mounting to the Service

Conditioning Module. The unit has three (3) RJ45 connectors

for interfacing to the telephone distribution network. The unit

is packaged with a six inch Cat 5e Jumper (PN 363201-27).

3. Installation

A. Mounting the Unit to the Service Conditioning Module

(see Figure 2)

1. Install the Telecom Service Conditioning Module in

Enclosure per instructions included with module (ref.

IS-0204).

Note: The Enclosure and module must be properly

installed and grounded for Surge Conditioning Units

to function.

2. Position the unit on the module by aligning the tab

on the housing with one of the three (3) recess cuts

on the module.

Note: Up to three (3) Conditioning Units may be installed, in series, on a single module. It is

recommended that the Surge Unit be the first unit in series from the incoming service.

3. Align the captive screw with the appropriate threaded insert. Use a Philips screwdriver to attach unit to

the module.

B. Connecting to the Telecom Network (see Figure 3)

1. Incoming Service is to be terminated into an RJ45 plug. This may be through an EZ-RJ45 Modular Plug, PN

364554-01, being terminated to the incoming service cable; or, by using a Cat 5e Jumper cable from the

service, terminated to an RJ45 interface, such as the On-Q Network Interface, PN 363486-01.

2. Connect the Line Out to the Telephone Distribution System or the next Conditioning Unit in series. Use the

Cat 5e Jumper provided.

3. Connect the security system with the RJ31X cable provided with the security system.

Figure 1

Figure 2

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

Page 2 of 2

INSTRUCTION/INSTALLATION SHEET

SECURITY INTERFACE CONDITIONING

UNIT

IS-0211 REV. A

NOTE: The circuit will be open unless (or until) the security system is interfaced.

Figure 3

Legrand Security Interface Conditioning Unit, IS-0211 Installation guide

Legrand Security Interface Conditioning Unit, IS-0211 Installation guide

Legrand Security Interface Conditioning Unit, IS-0211 Installation guide

Related papers

Other documents