Commercial Electric NS01cA09FR2-259 Installation guide

Type
Installation guide

This manual is also suitable for

The factory setting of the spring clips
is for 6in.housing.
If using a 5 in. housing, loosen the
screws on the torsion spring and
slide the brackets outward. Re-tighten
screws to secure torsion spring in place.
Item #1002 936 217
Model #NS01aA11FR1-259
Item #1002 936 208
Model #NS01aA11FR1-259
Item #1002 936 204
Model #NS01aA11FR1-259
Plug the female connector of the retrot trim into
the male connector of the compatible housing.
Squeeze both torsion spring arms together and insert
into the torsion spring slots of the can. Tuck all wires
into the can and carefully push the retrot trim into
the can.
Unscrew the two spring clips and
remove them.
Install two friction blades (A) onto the xture.
For 5in. housing, tighten the screws into the
holes with Phillips screwdriver.
For 6in. housing, tighten the screws into the
holes with Phillips screwdriver.
Plug the female connector of the retrot trim into
the male connector of the compatible housing.
Insert into the friction blades slots of the can. Tuck all wires
into the can and carefully push the retrot trim into
the can.
Model Input Volts (Vac) Input Frequency (Hz) Input Watts (W)
NS01aA11FR1-259 120 60 9
0
30
60
90
120
150
-/+180
-150
-120
-90
-60
-30
UNIT:cd
C0/180,95.4deg
UNIT:cd
C90/270,95.5deg
AVERAGE BEAM ANGLE(50%):95.4 DEG
0
70
140
210
280
350
210*290mm
Installation using friction blades
Installation using spring clips
(A)
Package Contents
SKU Part Description Quantity
A Friction Clip 2
B .1181X1/8 in Screw 2
A Friction Clip 4
B .1181X1/8 in Screw 4
A Friction Clip 8
B .1181X1/8 in Screw 8
1002936204
1002936208
1002936217
Pre-Installation
  • Page 1 1

Commercial Electric NS01cA09FR2-259 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI