2. Toro
  3. 36in Baffle Kit, TURBO FORCE Cutting Unit for Mid-Size Mowers

Toro 36in Baffle Kit, TURBO FORCE Cutting Unit for Mid-Size Mowers Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Toro 36in Baffle Kit, TURBO FORCE Cutting Unit for Mid-Size Mowers Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Form No. 3354-114 Rev A
36in Bagger Enhancement Kit
For Turbo Force® Cutting Unit for Mid-Size Mowers
Model No. 110–2026
Installation Instructions
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
No parts required
–
Prepare the mower deck for
installation.
Rubber bafe
1
Metal bafe stiffener
1
Carriage bolt (5/16 x 1 inch)
5
2
Locknut (5/16 inch)
5
Install the bafes.
Step
1
Preparing the Mower Deck
No Parts Required
Procedure
1. P osition the mo w er on a flat surface .
2. Diseng ag e the PTO , mo v e the motion control
lev ers to the neutral loc k ed position and set
the parking brak e .
3. Stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
4. Lift the front of the mac hine and suppor t the
mac hine using jac k stands .
5. T horoughly clean the mo w er dec k. All debris
m ust be remo v ed to ensure the baffle will fit
properly ag ainst the mo w er dec k.
6. R e pair all bent and damag ed areas of the
mo w er dec k and re place any missing par ts .
Mechanical or h y draulic jacks may f ail to
suppor t the machine and cause a serious
injur y .
• Use jack stands when suppor ting the
machine.
• Do not use h y draulic jacks.
Step
2
Installing the Bafes
Parts needed for this step:
1
Rubber bafe
1
Metal bafe stiffener
5
Carriage bolt (5/16 x 1 inch)
5
Locknut (5/16 inch)
Procedure
Note: Install bolts as sho wn in Figure 1 .
1. Install r ubber baffle and the baffle stiffener
with 5 bolts (5/16 x 1 inc h) and 5 loc kn uts
(5/16 inc h) ( Figure 1 ).
2. R otate the cutting blades and mak e sure they
do not hit the baffles .
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Figure 1
1. Mower deck 4. Bafe stiffener
2. Locknut (5/16 inch) 5. Carriage bolt (5/16 x 1
inch)
3. Rubber bafe
2
/