This add-on harness, when used with an existing KC harness, will enable you to power

one or two additional lights with the switch on your existing harness.

1. Mount the relay within 6” of the relay on your existing light harness using one of the

screws enclosed.

2. With one of the screws enclosed, attach the ring terminal on the black ground wire to a

good clean metal grounded surface. (the relay mounting screw may be a good ground)

3. Run each of the red and black wire sets out to your two new additional KC lights and plug

the red wire into the red on the light and the black wire to the black on the light.

4. Using the enclosed wire splice, attach the 8” green wire from the add-on harness to the

Installation Instructions

KC 6316 Add-on Harness

for 2 Additional Lights

KC HiLiTES, Inc., 2843 West Avenida de Luces, PO Box 155, Williams, AZ 86046 * 800-528-0950 * www.kchilites.com KC 3264V - rev 100604

23 Year Warranty

See details on our website at

www.kchilites.com