Page is loading ...
Network Appliance FWS- 7 250
FWS-7250
1U Rackmount
Network Appliance Platform
Internal 2.5” SATA HDD x1
or 3.5” SATA HDD x 1
or 2.5” SATA HDD x 2
CF SATA Socket
4 LAN Ports
2 USB2.0, 1 COM for Console
1 MiniCard Slot
FWS-7250 Manual 2
nd
Ed.
February 14, 2019
Network Appliance FWS- 7250
i
Copyright Notice
This document is copyrighted, 2019. All rights are reserved. The
original manufacturer reserves the right to make improvements to the
products described in this manual at any time without notice.
No part of this manual may be reproduced, copied, translated, or
transmitted in any form or by any means without the prior written
permission of the original manufacturer. Information provided in this
manual is intended to be accurate and reliable. However, the original
manufacturer assumes no responsibility for its use, or for any in-
fringements upon the rights of third parties that may result from its
use.
The material in this document is for product information only and is
subject to change without notice. While reasonable efforts have been
made in the preparation of this document to assure its accuracy,
AAEON assumes no liabilities resulting from errors or omissions in
this document, or from the use of the information contained herein.
AAEON reserves the right to make changes in the product design
without notice to its users.
Network Appliance FWS- 7250
ii
Acknowledgments
All other products’ name or trademarks are properties of their
respective owners.
Intel
®
and Atom™ are trademarks of Intel
®
Corporation.
AMI is a trademark of American Megatrends Inc.
CompactFlash™ is a trademark of the Compact Flash
Association.
Microsoft Windows
®
is a registered trademark of Microsoft Corp.
All other product names or trademarks are properties of their
respective owners.
Network Appliance FWS- 7250
iii
Packing List
Before installation, please make sure that the following
materials have been shipped:
FWS-7250
Gift Box (Including Console Cable, Ear Brackets)
If any of these items should be missing or damaged, please
contact your distributor or sales representative immediately.
Note:
VGA Cable is an optional accessory. Please only purchase
cable with the following item number.
1700160150 VGA Cable (must be used with two
S21D305011 screws)
Network Appliance FWS- 7250
iv
Contents
Chapter 1 General Information
1.1 Introduction ....................................................... 1-2
1.2 Features ............................................................ 1-3
1.3 Specifications .................................................... 1-4
1.4 General System Information .............................. 1-8
Chapter 2 Quick Installation Guide
2.1 Safety Precautions ............................................ 2-2
2.2 Location of Connectors of Main Board ............... 2-3
2.3 Mechanical Drawing of Main Board ................... 2-5
2.4 List of Jumpers .................................................. 2-7
2.5 List of Connectors ............................................. 2-7
2.6 Setting Jumpers ................................................ 2-9
2.7 Auto Power Button (JP1) ................................... 2-10
2.8 CF Power Selection (CN13)............................... 2-10
2.9 CMOS Setting Selection (CN16) ........................ 2-10
2.10 RTC Test Setting Selection (CN17) ................. 2-11
2.11 24-Pin ATX Power Connector (CN1) ................ 2-12
2.12 Power Button (CN2) ........................................ 2-13
2.13 SIM Card Socket (CN4) ................................... 2-13
2.14 Compact Flash Socket (CN5) .......................... 2-14
2.15 LCM Connector (CN6) ..................................... 2-16
2.16 PS2 Keyboard/Mouse Pin Header (CN8) ......... 2-17
Network Appliance FWS- 7250
v
2.17 SATA Port Connector (CN9) ............................ 2-18
2.18 SATA Power Connector (CN10 & CN14) ......... 2-18
2.19 USB2.0 Port 1 Pin Header (CN11) ................... 2-19
2.20 VGA Pin Header (CN12) .................................. 2-20
2.21 SATA Port Connector (CN15) .......................... 2-21
2.22 Mini PCI-E Slot (CN19) .................................... 2-21
2.23 USB2.0 Type-A Connector (CN20) .................. 2-24
2.24 Console Port Connector (CN21) ...................... 2-24
2.25 Giga LAN Port Connector (CN22) .................... 2-25
2.26 Giga LAN Port Connector (CN23) .................... 2-26
2.27 Giga LAN Port Connector (CN24) .................... 2-26
2.28 Giga LAN Port Connector (CN25) .................... 2-27
2.29 COM Port Connector (COM1) .......................... 2-28
2.30 4-pin Fan Connector (CPU_FAN1) .................. 2-30
2.31 Front Panel Connector (FP1) ........................... 2-30
2.32 Front Panel Connector (FP2) ........................... 2-31
2.33 4-pin Fan Connector (SYS_FAN1) ................... 2-31
2.34 Installing the 2.5” Hard Disk Drive .................... 2-32
2.35 Installing the 3.5” Hard Disk Drive .................... 2-36
Chapter 3 AMI BIOS Setup
3.1 System Test and Initialization ............................ 3-2
3.2 AMI BIOS Setup ................................................ 3-3
Chapter 4 Driver Installation
4.1 Installation ......................................................... 4-3
Network Appliance FWS- 7250
vi
Appendix A Programming the Watchdog Timer
A.1 Watchdog Timer Initial Program .................... A-2
Network Appliance FWS- 7250
Chapter 1 General Information 1- 1
General
Information
Chapter
1
Network Appliance FWS- 7250
Chapter 1 General Information 1- 2
1.1 Introduction
FWS-7250 adopts the Intel
®
Quad-Core Celeron™ J1900
Processor. The system memory features two 204-pin Dual channel
DDR3L 1333MHz SODIMM slots up to 8GB. It deploys four
Gigabit Ethernet LAN ports with two pairs LAN bypass function. The
condensed appearance of FWS-7250 features 1U form factor that
fits nicely into a space- limited environment.
This compact FWS-7250 can be equipped with one 3.5”/2.5” SATA
HDD and CF-SATA socket or two 2.5” SATA HDD. In addition, it
offers flexible expansion with network products and features one
Mini-Card slot with SIM socket, two USB2.0 ports and one RS-232
console port on the front panel. The console port deploys console
re-direction that increases the network security via remote control.
Moreover, the front panel supports LCM with keypad control for
easy access and operation. All of these designs provide for a more
user-friendly solution.
Network Appliance FWS- 7250
Chapter 1 General Information 1- 3
1.2 Features
1U Rackmount 4 LAN ports Network Appliance
Intel® Atom™ E3845, up to 1.91 GHz or Celeron® J1900 up
to 2.42 GHz
Two 204-pin Dual Channel DDR3L 1333MHz SODIMM Up to
8GB
Intel® I210AT, 10/100/1000Base-TX Ethernet Port x 4
Internal 2.5” SATA HDD x 1 or (2.5” SATA HDD x 2 /3.5”
SATA HDD x 1 optional), CompactFlash™ Socket x 1
RJ-45 Console x 1, USB 2.0 x 2
100W ATX PSU
Network Appliance FWS- 7250
Chapter 1 General Information 1- 4
1.3 Specifications
Platform
Form Factor
1U Rackmount Network Platform
Processor
Intel® Atom™ E3845, up to 1.91 GHz/
Celeron® J1900 up to 2.42 GHz
Chipset
Integrated
System Memory
DDR3(L) 1333 SODIMM, u
p to 8GB, 204
Pin DIMM x 2
Network
Ethernet
Intel® i210AT, Gigabit Ethernet x 4
Bypass
2
NIM Slot
—
Display
Graphic Controller
Intel® Integrated
Connector
VGA cable (Optional)
Storage
HDDs
Internal 2.5” SATA HDD x 1 or (2.5” SATA
HDD x 2 /3.5” SATA HDD x 1 optional)
CF/CFast/mSATA
CF socket x 1
Network Appliance FWS- 7250
Chapter 1 General Information 1- 5
Expansion/Internal Interface
PCIe slot
—
Mini-Card slot
1
IPMI
—
Keyboard and
Mouse
Pin-header
Universal Serial Bus
USB 2.0 x1 Box Header (2.0mm)
(optional)
Miscellaneous
RTC
Internal RTC
Watchdog Timer
1~255 steps by software programmable
Software Button
GPIO Programmable push button x 1
TPM
—
GPIO
—
FAN
2
MTBF (Hours)
110,000
Color
Black
Network Appliance FWS- 7250
Chapter 1 General Information 1- 6
Environmental Parameters and Dimension
Power Requirement
100W ATX PSU
Operation Temp.
32°F ~ 104°F (0°C ~ 40°C)
Storage Temp.
-4°F ~ 140°F (-20°C ~ 60°C)
Operating Humidity
10% ~ 80%
Storage Humidity
10% ~ 80% @ 40°C, non-condensing
Vibration
0.5 Grms/ 5 ~ 500Hz/ operation (3.5”
H.D.D)
1.5 Grms/ 5 ~ 500Hz/ no operation
Shock
10G peak acceleration (11 m sec.
duration), operation
20G peak acceleration (11 m sec.
duration), non-operation
Chassis Dimension
(W x D x H)
16.93” x 11.02” x 1.73” (430mm x 280mm
x 44mm)
Network Appliance FWS- 7250
Chapter 1 General Information 1- 7
I/O Interfaces
Front Panel
- Power LED x 1
- Status LED x 1
- HDD Active LED x 1
- LAN ports Link/Active LED x 4
- Bypass LED (Default 2 LEDs)
- USB 2.0 Ports x 2
- RJ-45 Console x 1
- Parallel LCM display and 4 keypad x 1
- Software Programmable Switch x 1
Rear Panel
- AC Power Input x 1
- Power Switch x 1
- VGA port (Optional)
Network Appliance FWS- 7250
Chapter 1 General Information 1- 8
1.4 General System Information
Network Appliance FWS- 7 250
Chapter 2 Quick Installation Guide 2-1
Quick
Installation
Guide
Chapter
2
Network Appliance FWS- 7 250
Chapter 2 Quick Installation Guide 2-2
2.1 Safety Precautions
The installation is intended for technically qualified personnel who
have experience installing and configuring system boards.
The equipment can be installed in a restricted access location (RAL)
only.
A restricted access location is a site location for equipment where
the following criteria apply:
01. Access can only be gained by service persons or by users who
have been trained on the restrictions and the precautions for this
specific site.
02. Access is by means of at least one of the following, special tool,
lock and key, or other means of security, and is controlled by the
authority responsible for the location.
Safety Precautions:
Always completely disconnect the power cord
from your board whenever you are working on
it. Do not make connections while the power is
on, because a sudden rush of power can
damage sensitive electronic components.
Always ground yourself to remove any static
charge before touching the board. Modern
electronic devices are very sensitive to static
electric charges. Use a grounding wrist strap at
all times. Place all electronic components on a
static-dissipative surface or in a static-shielded
bag when they are not in the chassis
Network Appliance FWS- 7 250
Chapter 2 Quick Installation Guide 2-3
2.2 Location of Connectors of Main Board
Network Appliance FWS- 7 250
Chapter 2 Quick Installation Guide 2-4
Network Appliance FWS- 7 250
Chapter 2 Quick Installation Guide 2-5
2.3 Mechanical Drawing of Main Board
/
