ABH H1803 Operating instructions

Brand
ABH
Model
H1803
Type
Operating instructions
H1803
ISSUED 12-16-21
H1803-00.DWG
c 2021 ABH Mfg., Inc.
printed in USA
www.abhmfg.com
E-mail: [email protected]
Architectural Builders Hardware Mfg., Inc.
1222 Ardmore Ave., Itasca, IL 60143
630.875.9900; FAX 800.9FAXABH (932.9224)
PAGE 1 OF 1
H1803 FLOOR MOUNT DOOR STOP
4 3/8"
Installing Floor Stop in Concrete Floor
1. Determine location of floor stop in floor.
NOTE: WHEN POSSIBLE INSTALL WELL OUT OF FOOT TRAFFIC
2. Drill 1-1/4” wide hole in concrete floor per the rod depth provided.
3. Once drilled, clean out any dust or debris and fill the drilled hole with Wet Quick-Dry
Cement approximately 60% full.
4. Push floor stop into wet cement all the way down, removing any excess cement that
has pushed up from the hole. Verify the floor stop is centered and vertical in the
cement.
5. Let Dry completely before use. Cement drying time will vary on quick-dry cement
instructions.
Ø4"
1 3/8"
Ø5/8"
1"
3"
Ø1 1/4"
BLACK RUBBER
BUMPER
CONCRETE
FLOOR
QUICK DRY
CEMENT
FINISHED
FLOOR
ROD
  • Page 1 1

ABH H1803 Operating instructions

Brand
ABH
Model
H1803
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents