Electrolux Z5307 User manual

Category
Vacuum cleaners
Type
User manual

This manual is also suitable for

Electrolux Z5307 is a versatile and powerful vacuum cleaner that is perfect for keeping your home clean and tidy. With its range of features and accessories, it can tackle any cleaning task, from hard floors to carpets and upholstery.

The Electrolux Z5307 comes with a variety of nozzles and brushes, so you can customize your cleaning to suit your needs. The floor nozzle is perfect for cleaning hard floors and carpets, while the furniture brush is ideal for dusting and cleaning delicate surfaces. The crevice nozzle is great for getting into hard-to-reach places, and the upholstery nozzle is perfect for cleaning sofas, chairs, and other upholstered furniture.

Electrolux Z5307 is a versatile and powerful vacuum cleaner that is perfect for keeping your home clean and tidy. With its range of features and accessories, it can tackle any cleaning task, from hard floors to carpets and upholstery.

The Electrolux Z5307 comes with a variety of nozzles and brushes, so you can customize your cleaning to suit your needs. The floor nozzle is perfect for cleaning hard floors and carpets, while the furniture brush is ideal for dusting and cleaning delicate surfaces. The crevice nozzle is great for getting into hard-to-reach places, and the upholstery nozzle is perfect for cleaning sofas, chairs, and other upholstered furniture.

NewAegBookCover 2003.03.28 11:31 Page 1
NewAegBookCover 2003.03.28 11:31 Page 2
NewAegBookCover 2003.03.28 11:31 Page 3
2190453-08
NewAegBookCover 2003.03.28 11:31 Page 4
Safety information 2
Exploded view and assembly 4
Vacuum Cleaning 6
Nozzles 8
Emptying dust collector/cleaning filters 10
Transport and storage 12
Maintenance and cleaning 14
What do if... 16
For the sake of the environment 18
Spares 20
Service 22
Guarantee 24
NewAEGMainBook 2003.04.01 13:40 Page 1
Dear Customer
Please read these operating instructions care-
fully. Pay particular attention to the safety
information! Please keep the operating
instructions for future reference.
Pass them on to any future owner of the appli-
ance.
Before you start
Check the voltage
First check the voltage shown on the data
plate (see rear view) to make sure that the
cleaner is of the correct voltage for your elec-
tricity supply. If it is not, do not use the cleaner
but refer back to your dealer.
Connecting to your electricity supply
Permanently connected to the cleaner is a
mains supply (2-core) cable fitted with a
non-rewirable plug incorporating a 13A fuse.
In the event of a fuse requiring replacement
the fuse cover should be removed using a
small screwdriver. The old fuse MUST be
replaced by a 13A ASTA approved BS1362
fuse or a BSI approved fuse. The cover must
be replaced before the plug is used again. In
the event of loss of the fuse cover, replace-
ments can be obtained from your Electrolux
Retailers and must be of the same colour as
indicated by the coloured insert on the base of
the plug.
If difficulty is experienced in obtaining a
replacement, contact Electrolux on 08706
055055.
In no circumstances must the plug be used
without a correct fuse cover fitted.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut
off and the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to
prevent the hazard of shocks in case it should
be plugged into a 13 amp socket in another
part of your home.
The wires in the mains cable of this appliance
are coloured in accordance with the following
code: Blue: Neutral. Brown: Live.
As the colours of the wires in the mains cable
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is
coloured blue must be
connected to the termi-
nal which is marked with
the letter N or coloured
black.
The wire which is
coloured brown must be
connected to the termi-
nal which is marked with
the letter L or coloured
red.
If using a three-pin plug, do not make any
connection to the terminal marked with the
letter E or by the earth symbol or coloured
green or green-and-yellow. This cleaner is
double insulated and no earth connection is
necessary.
It is in your interest to ensure that the plug is
correctly attached to the mains cable. In case
of doubt, have it done by a qualified electri-
cian, as Electrolux cannot regard the repair of
faults on the plug connection as a service that
can be given free of charge under the terms of
the guarantee.
2
English
2
English
NewAEGMainBook 2003.04.01 13:40 Page 2
Safety information
Power supply: AC only 220/230 V, fuse 13A
(see also „Before you start“, page 2).
• Do not put the unit into service if:
– the connecting lead is damaged,
– the unit is visibly damaged.
Use only in the home for cleaning dry mate-
rial. People and animals must not be treated
with the unit. Keep children away from elec-
trical appliances.
If you vacuum building or plaster dust,
please remove and clean, or replace the fil-
ters before reusing
Do not vacuum:
Liquids. Allow damp cleaned fitted carpet
to dry out completely.
– Matchsticks, glowing ash or cigarette
ends.
– Hard, pointed objects.
Toner dust (from laser printers, photo-
copiers).
Never pull the mains plug from the socket
with the cord. Do not run over the mains
cable with the unit and suction brush.
Do not clean unit with water (except fil-
ters and dust collector as per the instruc-
tions).
Do not expose the unit to the effects of
weather, moisture or sources of heat.
• Dust collector or a paper dust bag and all fil-
ters must always be fitted. If no dust col-
lector or paper dust bag is fitted, the
dust-collector compartment cover cannot
be closed. Please do not use force!
• Repairs to electrical appliances must be car-
ried out by qualified service engineers.
Improperly performed repairs can result in
considerable danger for the user.
If the power cable is defective the entire
cable roller must be exchanged by the AEG
customer service or an authorised work-
shop.
The manufacturer accepts no liability for any
damage caused by improper use or incorrect
operation.
In the event of a fault please contact your spe-
cialist dealer or the Electrolux customer
service directly.
This vacuum cleaner complies with the fol-
lowing EU Directives
• 73/23/EEC of 19.02.1973 – Low Voltage
Directive.
• 89/336/EEC of 03.05.1989 (including
revised Directive 92/31/EEC) – EMC
Directive.
NewAEGMainBook 2003.04.01 13:40 Page 3
Exploded view and assembly
A Cable rewind foot switch
B Foot switch ON/OFF
C Empty dust collector/Clean filter indicator
D Opener for dust-collector
E Suction hose
F Accessories holder *
G Suction control *
H Metal tubes (2)* / Telescopic tube*
J Floor nozzle * compartment
K Power cable
* depending on model
4
English
NewAEGMainBook 2003.04.01 13:40 Page 4
Vacuum cleaning
Withdraw cable, insert mains plug.
(To roll the cable up press foot switch A.
Please hold the plug.)
• Switch on/off with foot switch B (on the low-
est power setting, there may be a
start delay up to 4 seconds due to the elec-
tronic starting current limiter *).
• Suction capacity can be reduced by opening
the suction control G *.
If you open the suction control G on the bent
end, you can reduce the force required to push
the nozzle across the carpet, and enable you
to clean lightweight rugs, curtains and uphol-
stery.
* depending on model
NewAEGMainBook 2003.04.01 13:40 Page 5
Nozzles
L Floor nozzle *, dual purpose for carpets and
hard floors
M Furniture brush *
N Crevice nozzle *
O Upholstery nozzle * (threads and fluff are
effectively removed)
* depending on model
6
English
NewAEGMainBook 2003.04.01 13:40 Page 6
Emptying dust collector/
cleaning filters
We recommend emptying the dust collector
after each use, but no later than when indi-
cator C shows red all over (with the unit
switched to maximum suction capacity and
the nozzle raised from the floor). If neces-
sary, also brush dust from the collector filter.
Figs. 1-3.
Caution: open dust-collector compart-
ment cover fully until it locks in place!
After washing the dust collector, please
allow to dry thoroughly before refitting.
If the suction power falls off noticeably
even after the dust collector has been
emptied (or if indicator C is red), rinse out
all filters under hot running water. Allow
to fully dry before refitting. Figs. 4-6.
Replace filters if necessary.
* depending on model
NewAEGMainBook 2003.04.01 13:40 Page 7
Transport and storage
8
English
NewAEGMainBook 2003.04.01 13:40 Page 8
Maintenance and cleaning
Before starting maintenance or cleaning,
switch off the unit and withdraw the
mains plug.
Wipe over unit and dust-collector compart-
ment if necessary with a damp cloth
and allow to dry. Do not use abrasive materials
or solvents. Clean floor nozzle and
brush webs occasionally with the crevice noz-
zle.
Do not wash the dust collector in a dishwasher
or clean with aggressive detergents.
(This could damage or dull the dust collector).
What to do if...
...it is difficult to move the nozzle: reduce
the suction capacity. This does not reduce the
cleaning effect.
...the motor overheating protection has
switched off the unit: e.g. owing to overload
of the motor, by full dust collector or blocked
tools.
Check dust collector, filters, suction tube and
suction hose, remove any blockage. The unit
can be switched on again after approx 30 to
60 minutes.
...the fuse has blown: the fuse can blow if
other electrical units with high consumption
are used at the same time as the vacuum
cleaner from the same circuit.
In this case before switching on set the suc-
tion capacity control to the lowest level and
only select a higher level after switching on.
For the sake of the environment
Do not simply discard packing material and
used units!
Unit packing: we recommend preserving the
packing material for the term of the warranty
to permit reliable transport.
Take the polyethylene (PE) bag to a PE recy-
cling bank.
Recycling the vacuum cleaner at the end of
its service life: the plastic parts are identified
by a material code, so that they can be recy-
cled at the end of the service life of the vacu-
um cleaner in the same way as other materi-
als.
Your local authority environment office will
provide information on the location of the
nearest recycling facility.
Spares
New filters, dust bags, brush rollers and drive
belts can be obtained from Authorised
Electrolux Dealers and electrical retailers. If
difficulty is experienced in obtaining spares
please call us on 08706 055055.
Service
Should you require service on your Electrolux
cleaner, please telephone Electrolux on 08706
055055. Before requesting service, please
check whether your problem is covered under
Service Checklist (see below).
Guarantee
This guarantee is in addition to your statu-
tory and other legal rights.
This product is for household use only.
Electrolux products are carefully designed,
manufactured, tested and inspected and, in
consequence, we undertake to replace or
repair any part found to be defective in materi-
al or workmanship, within one year of delivery
to the original purchaser, free of charge. You
may be required to take the product to your
nearest service provider if the product requires
attention during the first year.
There are certain conditions which may invali-
date this guarantee:
a. It is dependent upon the appliance being
correctly installed and used in accordance
with the Company's instructions under nor-
mal domestic conditions within the United
Kingdom or the Republic of Ireland.
b. Service at all times must be carried out by
an Electrolux Service Representative or
authorised agent.
NewAEGMainBook 2003.04.01 13:40 Page 9
c. The guarantee may be invalidated by unau-
thorised repair or modification of the appli-
ance.
d. You may be charged by Electrolux if you
call for an engineer to resolve a problem
that we believe is covered in the instruction
booklet (example: blocked/dirty filters).
The Company does not accept liability for
defects arising from neglect, misuse or acci-
dent. This guarantee excludes such normal
wearing parts as drive belts, brushes, filters
and dust bags as the life of these depends
upon the amount and nature of use.
Proof of the date of purchase (ie till receipt)
will be required before service under guaran-
tee is provided. Please call 08706 055055 for
assistance.
Important:
For future reference we suggest you record
the following details here, and keep the
receipt with the handbook as proof of pur-
chase.
Purchased from
Date purchased Model no
________________________________________________________________
_________________ ___________________________________
10
English
NewAEGMainBook 2003.04.01 13:40 Page 10
NewAEGMainBook 2003.04.01 13:40 Page 11
12
English
ELECTROLUX FLOORCARE (UK)
101 OAKLEY ROAD
LUTON LU4 9QQ
Customer Helpline 08706 055055
htpp://www.electrolux.com
NewAEGMainBook 2003.04.01 13:40 Page 12
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16

Electrolux Z5307 User manual

Category
Vacuum cleaners
Type
User manual
This manual is also suitable for

Electrolux Z5307 is a versatile and powerful vacuum cleaner that is perfect for keeping your home clean and tidy. With its range of features and accessories, it can tackle any cleaning task, from hard floors to carpets and upholstery.

The Electrolux Z5307 comes with a variety of nozzles and brushes, so you can customize your cleaning to suit your needs. The floor nozzle is perfect for cleaning hard floors and carpets, while the furniture brush is ideal for dusting and cleaning delicate surfaces. The crevice nozzle is great for getting into hard-to-reach places, and the upholstery nozzle is perfect for cleaning sofas, chairs, and other upholstered furniture.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI