Electrolux Z5310 GB User manual

Brand: Electrolux

Model: Z5310 GB

Category: Vacuum cleaners

Type: User manual

Electrolux Z5310 GB is your high-performing vacuum cleaner for thorough cleaning results. Equipped with a large dust collector, this vacuum cleaner is ideal for all types of flooring, from hard floors to carpets. The suction power can be adjusted to suit your cleaning needs, and the included nozzles make it easy to clean even hard-to-reach areas. With its lightweight design and easy-to-use features, the Electrolux Z5310 GB is the perfect choice for a quick and effective clean.

2190453-13 BookCover 2004.02.25 13:26 Page 1

Before you start 2

Safety information 3

Exploded view and assembly 4

Vacuum Cleaning 5

Nozzles 6

Emptying dust collector/cleaning filters 7

Transport and storage 8

Maintenance and cleaning 9

What do if... 9

For the sake of the environment 9

Spares 9

Service 9

Guarantee 9

Dear Customer

Please read these operating instructions care-

fully. Pay particular attention to the safety

information! Please keep the operating

instructions for future reference.

Pass them on to any future owner of the appli-

ance.

Before you start

Check the voltage

First check the voltage shown on the data

plate (see rear view) to make sure that the

cleaner is of the correct voltage for your elec-

tricity supply. If it is not, do not use the cleaner

but refer back to your dealer.

Connecting to your electricity supply

Permanently connected to the cleaner is a

mains supply (2-core) cable fitted with a

non-rewirable plug incorporating a 13A fuse.

In the event of a fuse requiring replacement

the fuse cover should be removed using a

small screwdriver. The old fuse MUST be

replaced by a 13A ASTA approved BS1362

fuse or a BSI approved fuse. The cover must

be replaced before the plug is used again. In

the event of loss of the fuse cover, replace-

ments can be obtained from your Electrolux

Retailers and must be of the same colour as

indicated by the coloured insert on the base of

the plug.

If difficulty is experienced in obtaining a

replacement, contact Electrolux on 08706

055055.

In no circumstances must the plug be used

without a correct fuse cover fitted.

If the plug that is fitted to your appliance is not

suitable for your socket outlet, it must be cut

off and the appropriate plug fitted.

Remove the fuse from the cut off plug.

The cut off plug should then be disposed of to

prevent the hazard of shocks in case it should

be plugged into a 13 amp socket in another

part of your home.

The wires in the mains cable of this appliance

are coloured in accordance with the following

code: Blue: Neutral. Brown: Live.

As the colours of the wires in the mains cable

of this appliance may not correspond with the

coloured markings identifying the terminals in

your plug, proceed as follows:

The wire which is

coloured blue must be

connected to the termi-

nal which is marked with

the letter N or coloured

black.

The wire which is

coloured brown must be

connected to the termi-

nal which is marked with

the letter L or coloured

red.

If using a three-pin plug, do not make any

connection to the terminal marked with the

letter E or by the earth symbol or coloured

green or green-and-yellow. This cleaner is

double insulated and no earth connection is

necessary.

It is in your interest to ensure that the plug is

correctly attached to the mains cable. In case

of doubt, have it done by a qualified electri-

cian, as Electrolux cannot regard the repair of

faults on the plug connection as a service that

can be given free of charge under the terms of

the guarantee.

English

Safety information

• Power supply: AC only 220/230 V, fuse 13A

(see also „Before you start“, page 2).

• Do not put the unit into service if:

– the connecting lead is damaged,

– the unit is visibly damaged.

• Use only in the home for cleaning dry mate-

rial. People and animals must not be treated

with the unit. Keep children away from elec-

trical appliances.

• If you vacuum building or plaster dust,

please remove and clean, or replace the fil-

ters before reusing

• Do not vacuum:

– Liquids. Allow damp cleaned fitted carpet

to dry out completely.

– Matchsticks, glowing ash or cigarette

ends.

– Hard, pointed objects.

– Toner dust (from laser printers, photo-

copiers).

• Never pull the mains plug from the socket

with the cord. Do not run over the mains

cable with the unit and suction brush.

• Do not clean unit with water (except fil-

ters and dust collector as per the instruc-

tions).

• Do not expose the unit to the effects of

weather, moisture or sources of heat.

• Dust collector or a paper dust bag and all fil-

ters must always be fitted. If no dust col-

lector or paper dust bag is fitted, the

dust-collector compartment cover cannot

be closed. Please do not use force!

• Repairs to electrical appliances must be car-

ried out by qualified service engineers.

Improperly performed repairs can result in

considerable danger for the user.

• If the power cable is defective the entire

cable roller must be exchanged by the AEG

customer service or an authorised work-

shop.

• The manufacturer accepts no liability for any

damage caused by improper use or incorrect

operation.

In the event of a fault please contact your spe-

cialist dealer or the Electrolux customer

service directly.

This vacuum cleaner complies with the fol-

lowing EU Directives

• 73/23/EEC of 19.02.1973 – Low Voltage

Directive.

• 89/336/EEC of 03.05.1989 (including

revised Directive 92/31/EEC) – EMC

Directive.

Exploded view and assembly

A Cable rewind foot switch

B Foot switch ON/OFF

C Empty dust collector/Clean filter indicator

D Opener for dust-collector

E Suction hose

F Tool storage *

G Suction control *

H Metal tubes (2)* / Telescopic tube*

J Floor nozzle * compartment

K Power cable

* depending on model

English

Vacuum cleaning

• Withdraw cable, insert mains plug.

(To roll the cable up press foot switch A.

Please hold the plug.)

• Switch on/off with foot switch B (on the low-

est power setting, there may be a

start delay up to 4 seconds due to the elec-

tronic starting current limiter *).

• Suction capacity can be reduced by opening

the suction control G *.

If you open the suction control G on the bent

end, you can reduce the force required to push

the nozzle across the carpet, and enable you

to clean lightweight rugs, curtains and uphol-

stery.

* depending on model

Nozzles

L Floor nozzle *, dual purpose for carpets and

hard floors

M Furniture brush *

N Upholstery nozzle*

(threads and fluff are effetively removed)

O Crevice nozzle

* depending on model

English

Emptying dust collector/

cleaning filters

• We recommend emptying the dust collector

after each use, but no later than when indi-

cator C shows red all over (with the unit

switched to maximum suction capacity and

the nozzle raised from the floor). If neces-

sary, also brush dust from the collector fil-

ter. Figs. 1-3.

Caution: open dust-collector compart-

ment cover fully until it locks in place!

After washing the dust collector, please

allow to dry thoroughly before refitting.

• If the suction power falls off noticeably

even after the dust collector has been

emptied (or if indicator C is red), rinse

out all filters under hot running water.

Allow to fully dry before refitting. Figs. 4-6.

Replace filters if necessary.

* depending on model

Transport and storage

English

Maintenance and cleaning

Before starting maintenance or cleaning,

switch off the unit and withdraw the

mains plug.

Wipe over unit and dust-collector compart-

ment if necessary with a damp cloth

and allow to dry. Do not use abrasive materi-

als or solvents. Clean floor nozzle and

brush webs occasionally with the crevice noz-

zle.

Do not wash the dust collector in a dishwasher

or clean with aggressive detergents.

(This could damage or dull the dust collector).

What to do if...

...it is difficult to move the nozzle: reduce

the suction capacity. This does not reduce the

cleaning effect.

...the motor overheating protection has

switched off the unit: e.g. owing to overload

of the motor, by full dust collector or blocked

tools.

Check dust collector, filters, suction tube and

suction hose, remove any blockage. The unit

can be switched on again after approx 30 to

60 minutes.

...the fuse has blown: the fuse can blow if

other electrical units with high consumption

are used at the same time as the vacuum

cleaner from the same circuit.

In this case before switching on set the suc-

tion capacity control to the lowest level and

only select a higher level after switching on.

For the sake of the environment

Do not simply discard packing material and

used units!

Unit packing: we recommend preserving the

packing material for the term of the warranty

to permit reliable transport.

Take the polyethylene (PE) bag to a PE recy-

cling bank.

Recycling the vacuum cleaner at the end of

its service life: the plastic parts are identified

by a material code, so that they can be recy-

cled at the end of the service life of the vacu-

um cleaner in the same way as other materi-

als.

Your local authority environment office will

provide information on the location of the

nearest recycling facility.

Spares

New filters, dust bags, brush rollers and drive

belts can be obtained from Authorised

Electrolux Dealers and electrical retailers. If

difficulty is experienced in obtaining spares

please call us on 08706 055055.

Service

Should you require service on your Electrolux

cleaner, please telephone Electrolux on 08706

055055. Before requesting service, please

check whether your problem is covered under

Service Checklist (see below).

Guarantee

This guarantee is in addition to your statu-

tory and other legal rights.

This product is for household use only.

Electrolux products are carefully designed,

manufactured, tested and inspected and, in

consequence, we undertake to replace or

repair any part found to be defective in materi-

al or workmanship, within one year of delivery

to the original purchaser, free of charge. You

may be required to take the product to your

nearest service provider if the product requires

attention during the first year.

There are certain conditions which may invali-

date this guarantee:

a. It is dependent upon the appliance being

correctly installed and used in accordance

with the Company's instructions under nor-

mal domestic conditions within the United

Kingdom or the Republic of Ireland.

b. Service at all times must be carried out by

an Electrolux Service Representative or

authorised agent.

c. The guarantee may be invalidated by unau-

thorised repair or modification of the appli-

ance.

d. You may be charged by Electrolux if you

call for an engineer to resolve a problem

that we believe is covered in the instruction

booklet (example: blocked/dirty filters).

The Company does not accept liability for

defects arising from neglect, misuse or acci-

dent. This guarantee excludes such normal

wearing parts as drive belts, brushes, filters

and dust bags as the life of these depends

upon the amount and nature of use.

Proof of the date of purchase (ie till receipt)

will be required before service under guaran-

tee is provided. Please call 08706 055055 for

assistance.

Important:

For future reference we suggest you record

the following details here, and keep the

receipt with the handbook as proof of pur-

chase.

Purchased from

Date purchased Model no

________________________________________________________________

_________________ ___________________________________

English

ELECTROLUX FLOORCARE (UK)

101 OAKLEY ROAD

LUTON LU4 9QQ

Customer Helpline 08706 055055

htpp://www.electrolux.com

Electrolux Z5310 GB User manual

Brand: Electrolux

Model: Z5310 GB

Category: Vacuum cleaners

Type: User manual

Download PDF

report

Electrolux Z5310 GB User manual

Electrolux Z5310 GB User manual

Related papers

Other documents