2. Computers & electronics
  3. Computer components
  4. Chassis components
  5. Racks
  6. Rack accessories
  7. Hikvision
  8. DS-3E2528-H

Hikvision DS-3E2528-H, DS-3E2528P-H, DS-3E2552-H Quick start guide

  • Hello! I've reviewed the Quick Start Guide for the HIKVISION DS-3E2500-H and DS-3E3700-H Switch Series. This document includes instructions for mounting the switch in a rack or on a workbench. It also details how to properly ground the device for safety and connect it to a power source. I'm ready to answer your questions about the switch installation process.
  • What tools are required for installation?
    How many screws are needed to attach a Type A mounting bracket?
    How many screws are needed to attach a Type B mounting bracket?
    Where can the mounting brackets be installed?
    Is it important to ground the switch?
2
1
22 3
1U
Attaching mounting brackets to the switch
Attach cage nuts to the rack posts Mount the switch in the rack
Mounting the switch on a workbench
Attach the rubber feet to the switch bottom
BOM: 3101A13S
HIKVISION DS-3E2500-H & DS-3E3700-H Switch Series Installation Quick Start-APW100
Type B mounting bracket
Type A mounting bracket Type A mounting bracket
Four screws are required to attach a Type A mounting bracket. Two screws are required to attach a
Type B mounting bracket.
Installation accessories
Wear an ESD wrist strap, and make sure the wrist strap makes good skin contact and is reliably
grounded.
The installation tools are not provided with the switch. Prepare them yourself as required.
1
Flathead screwdriver Phillips screwdriver Needle-nose pliers ESD wrist strap Marker
Cage nutGrounding cable M6 screw M4 countersunk-head screw
Tool list
!
Mounting brackets Rubber feet Grounding screw
Mounting the switch in a rack
The applicable mounting brackets vary by switch model. Some switch models provide two installation
positions on the two sides for mounting brackets: one at the port side and one at the power module
side. Select an installation position for the mounting brackets as required.
!
(Type A) (Type B)
The applicable installation accessories vary by switch model. Some accessories are not provided
with the switch. The packing list describes the accessories provided with the switch.
Cable tie
Example: Installation at the port side
Installation at the port side
Installation at the power module
side
Installation at the port side
12
Connect the grounding cable to a grounding strip
Connect the grounding cable to the switch
Installing and removing a power module
This section is applicable only to switch models that use removable power modules.
Before connecting the power cord, connect the grounding cable and make sure the switch is reliably
grounded.
To avoid bodily injury, connect the power cord first to the switch and then to the power supply system.
3
!
Connecting the power cord
Connecting the power cord for an AC power module.
Correctly connecting the switch grounding cable is crucial to lightning protection and EMI protection.
Use the grounding cable provided with the chassis to ground the switch.
Grounding the switch 1
2
1
Connecting the power cord for a DC power module.
2
12
Method 2
COPYRIGHT © 2022 Hangzhou Hikvision Digital Technology Co., Ltd.
For more information about the product and installation procedures, go to http://www.hikvision.com/en/
1
23
Method 1
1
2
1
2
2
1
Remove the filler panel Install a power module
/