®
BRILLIANT WONDERS QUICK START GUIDE
1
3
2
4
For Colorwheel Control Installation
Leave protective covers on the waterfall face and inlet
throughout the installation (to prevent debris from getting
into the product).
WATERFALL
Leave about 1/8” overhang after
tiles are installed
TILE
Connect power cable to LED strip. Clue
electrical cable PVC tting to back side.
Press in rectangle plug on opposite side.
Leave enough slack to allow servicing on
LED strip from front access door.
BODY SUPPORT CUTOUT
(2” wider than waterfall recommended)
Use electrical
conduit from
box to waterfall
STEEL REBAR SUPPORT
(Recommended)
ELECTRICAL NOTCH
(3.5” W x 3.0” D recommended)
PLUMBING NOTCH
(3.5” W x 3.5” D recommended)
NOTE: Larger waterfalls have 2 or
3 inlets.
CUSTOM MOLDED PRODUCTS | 36 HERRING ROAD, NEWNAN, GA 30265 | WWW.C-M-P.COM
ab0417
CONCRETE
5
7
6
PLUMBING DIAGRAM
Use 2” schedule 40 pipe on a dedicated pump and
suctions. Mount anti-vortex suction covers 18” above
bottom of pool. Always install at least two suctions per
pump as required by law. Filter strainer required. Install
rock trap on each waterfall. Rock trap does not
replace lter, ltered water must be used.
For two or more waterfalls, include a
ball valve for each waterfall to control
ow. Install a rock trap for each waterfall.
Do not cover access doors with tile, stone, or any substrate.
BALL VALVE
ROCK TRAP
TOUCH FULL-COLOR CIRCLE
SPEED KEYS
MODE KEYS
PAUSE KEY
SUCTION LINE
SEPARATE RETURN
TO POOL
ROCK TRAP
POOL WALL
PUMP
3-WAY VALVE
FILTER
WF
9
8
ON/OFF
PAUSE
KEYS
MODE
KEYS
SPEED
KEYS
BRIGHTNESS
KEYS
CLASS 2 POWER SUPPLY
100-240VAC INPUT12V OUTPUT
A/C INPUTD/C OUTPUT GROUND
BROWN
BLUE
GREEN
RED
RED
GREEN
BLACK
WHITE
BLACK
TO LED STRIP
FROM POWER
SUPPLY
WIRING DIAGRAM
REMOTE INSTRUCTIONS
The LTECH® T3 LED RGB Controller features
a user-friendly touch full-color wheel for color
selection, and unique LED light for a Sync
Status Indicator.
Remote functions can pause, change modes,
change speed, and change the brightness.
The remote comes with 32 built-in modes,
or you can save your favorite modes to the
Scene-Mode Keys.
KEY DESCRIPTION
ON/OFF Turn on and o the
receiver (or LED light).
PAUSE Press to stay on current
color.
MODE Press to select the next or
previous mode.
SPEED Press to speed up or slow
down.
BRIGHTNESS Press to increase or
decrease brightness.
TOUCH CIRCLE Touch color wheel to
select a color.
SCENE MODE Press 1-9 to load stored
modes.
Hold for 3 seconds to
store current mode.
Press Play to cycle modes.
To pair the remote with the control box press the ON/OFF key
on the control box for 3 seconds until a buzzer sounds. Press
any key on the remote within 5 seconds. Sync status light on
remote will blink 3 times and a buzzer sounds on control box.
Pairing is now complete.
TOUCH FULL-COLOR CIRCLE SYNC STATUS INDICATOR
SPEED KEYS
BRIGHTNESS KEYS
MODE KEYS
SCENE MODE KEYS
PAUSE KEY
ON/OFF KEY
WARNING
SUCTION LINE
SEPARATE RETURN
TO POOL
ROCK TRAP
POOL WALL
PUMP
3-WAY VALVE
FILTER
WF
AUTHORIZATION TO MARK
Applicant: Manufacturer:
Address: Address:
Countr
y
: Countr
y
:
Contact: Contact:
Phone: Phone:
FAX: FAX:
Email: Email:
Standard(s):
Product:
Models:
Custom Molded Products, Inc. Custom Molded Products - Shanghai
36 Herring Rd
Newman, GA 30265
859 Song Wei Rd.
Shanghai, Song Jiang Country 201600
USA China
Jesse Leech Mr. Ji
770-632-7112 ext. 232 011-86-21-57740077
770-632-7115 011-86-21-57742299
jleech@c-m-p.com emp150@gcbcmp.com
Party Authorized To Apply Mark: Same as Manufacturer
Report Issuing Office: Atlanta GA
Control Number:
4006147
Authorized by:
for Thomas J. Patterson, Certification Manager
This document supersedes all previous Authorizations to Mark for the noted Report Number.
This Authorization to Mark is for the exclusive use of Intertek's Client and is provided pursuant to the Certification agreement between Intertek and its Client. Intertek's responsibility and liability are
limited to the terms and conditions of the agreement. Intertek assumes no liability to any party, other than to the Client in accordance with the agreement, for any loss, expense or damage occasioned
by the use of this Authorization to Mark. Only the Client is authorized to permit copying or distribution of this Authorization to Mark and then only in its entirety. Use of Intertek’s Certification mark is
restricted to the conditions laid out in the agreement and in this Authorization to Mark. Any further use of the Intertek name for the sale or advertisement of the tested material, product or service must
first be approved in writing by Intertek. Initial Factory Assessments and Follow up Services are for the purpose of assuring appropriate usage of the Certification mark in accordance with the
agreement, they are not for the purposes of production quality control and do not relieve the Client of their obligations in this respect.
Intertek Testing Services NA Inc.
545 East Algonquin Road, Arlington Heights, IL 60005
Telephone 800-345-3851 or 847-439-5667 Fax 312-283-1672
UL Standard for Safety Underwater Luminaires and Submersible Junction Boxes, UL 676, Issued:
2003/6/9, Ed: 8, Rev 2013/12/19.
Swimming-Pool Luminaires, Submersible Luminaires and Accessories, CSA C22.2 No. 89-1976 (R2008).
Low Voltage Class 2 LED Waterfall luminaire
25676, 25677, 25686, 25687 followed by 6 digits
This authorizes the application of the Certification Mark(s) shown below to the models described in the Product(s)
Covered section when made in accordance with the conditions set forth in the Certification Agreement and Listing
Report. This authorization also applies to multiple listee model(s) identified on the correlation page of the Listing
Report.
This document is the property of Intertek Testing Services and is not transferable. The certification mark(s) may be
applied only at the location of the Party Authorized To Apply Mark.
Page 1 of 1 ATM for Report 101237883ATL-001A ATM Issued: 21-Oct-2014
ED 16.3.15 (1-Jan-13) Mandatory
AUTHORIZATION TO MARK
Applicant: Manufacturer:
Address: Address:
Countr
y
: Countr
y
:
Contact: Contact:
Phone: Phone:
FAX: FAX:
Email: Email:
Standard(s):
Product:
Models:
Custom Molded Products, Inc. Custom Molded Products - Shanghai
36 Herring Rd
Newman, GA 30265
859 Song Wei Rd.
Shanghai, Song Jiang Country 201600
USA China
Jesse Leech Mr. Ji
770-632-7112 ext. 232 011-86-21-57740077
770-632-7115 011-86-21-57742299
jleech@c-m-p.com emp150@gcbcmp.com
Party Authorized To Apply Mark: Same as Manufacturer
Report Issuing Office: Atlanta GA
Control Number:
4006147
Authorized by:
for Thomas J. Patterson, Certification Manager
This document supersedes all previous Authorizations to Mark for the noted Report Number.
This Authorization to Mark is for the exclusive use of Intertek's Client and is provided pursuant to the Certification agreement between Intertek and its Client. Intertek's responsibility and liability are
limited to the terms and conditions of the agreement. Intertek assumes no liability to any party, other than to the Client in accordance with the agreement, for any loss, expense or damage occasioned
by the use of this Authorization to Mark. Only the Client is authorized to permit copying or distribution of this Authorization to Mark and then only in its entirety. Use of Intertek’s Certification mark is
restricted to the conditions laid out in the agreement and in this Authorization to Mark. Any further use of the Intertek name for the sale or advertisement of the tested material, product or service must
first be approved in writing by Intertek. Initial Factory Assessments and Follow up Services are for the purpose of assuring appropriate usage of the Certification mark in accordance with the
agreement, they are not for the purposes of production quality control and do not relieve the Client of their obligations in this respect.
Intertek Testing Services NA Inc.
545 East Algonquin Road, Arlington Heights, IL 60005
Telephone 800-345-3851 or 847-439-5667 Fax 312-283-1672
UL Standard for Safety Underwater Luminaires and Submersible Junction Boxes, UL 676, Issued:
2003/6/9, Ed: 8, Rev 2013/12/19.
Swimming-Pool Luminaires, Submersible Luminaires and Accessories, CSA C22.2 No. 89-1976 (R2008).
Low Voltage Class 2 LED Waterfall luminaire
25676, 25677, 25686, 25687 followed by 6 digits
This authorizes the application of the Certification Mark(s) shown below to the models described in the Product(s)
Covered section when made in accordance with the conditions set forth in the Certification Agreement and Listing
Report. This authorization also applies to multiple listee model(s) identified on the correlation page of the Listing
Report.
This document is the property of Intertek Testing Services and is not transferable. The certification mark(s) may be
applied only at the location of the Party Authorized To Apply Mark.
Page 1 of 1 ATM for Report 101237883ATL-001A ATM Issued: 21-Oct-2014
ED 16.3.15 (1-Jan-13) Mandatory
CUSTOM MOLDED PRODUCTS | 36 HERRING ROAD, NEWNAN, GA 30265 | WWW.C-M-P.COM
ab0417
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
CMP 185583 Operating instructions
-
CMP 25513-4XX Operating instructions
-
CMP BRILLIANT WONDERS® LED WATERFALL 2 Operating instructions
-
-
-
-
-
-
-
Other documents
-
CMD 25503-564-100H User manual
-
Ltech M2 User manual
-
Super Bright LEDS MRKDX-X1 Series User manual
-
Time Electronics 7115 User manual
-
SALAV STM-501-2-KIT Operating instructions
-
Torin 8964884 Owner's manual
-
Barco Galaxy NW-7 MK I Owner's manual
-
Fagerhult 345 User manual
-
Stadler Form ZOE Blanc Product information
-
NightStick XPP-5422B/G User manual
