PRODUCT SHEET
GB
5019 437 01008
A. Refrigerator Compartment
1.
Lighting
2.
Shelves / Shelf area
2a.
Plastic shelf “Dual” (depending on the model)
3.
Cooler compartment (depending on the model)
4.
Rating plate
5.
Hygiene crisper
6.
Fan with Hygiene + filter (depending on the model)
7.
Removable shelf with a bottle holder
8.
Door trays
B. Freezer Compartment
9.
Upper basket (freezing zone)
10.
Ice tray
11.
Storage basket for frozen food items
12.
The freezer door trays for pizza or other frozen products
with a short storage time (depending on the model)
C. Control panel
Anti-bacterial protection:
Hygiene+ filter in fan
Hygiene crispers
Door seals
Notes:
The
Hygiene+ filter
ensures a higher level of hygiene in
your refrigerator through continuous purifying of circulating
air from bacteria. Remove it from the box (found in the
crisper drawer (item 5) and insert into the grille (item 6c)).
Replace the filter every 6 months.
1.
Remove the filter together with the grille and
dispose as a whole.
2.
Replace the filter and the grille with the new ones.
3.
The replacement procedure is attached with the
filter.
Our After-sales Service can supply this type of filter.
- The crispers and the door seals
are manufactured from
materials that inhibit bacterial growth.
- The internal temperatures of the appliance
depend on
the ambient temperature, frequency of opening the doors, as
well as location of the appliance. Take these factors into
consideration when setting the thermostat knobs.
- The number of shelves
and configuration of accessories
may vary, depending on the model. All shelves and door trays
are removable.
- The appliance accessories
are not suitable for washing in
a dishwasher.
The fridge-freezer is turned on by means of the thermostat
unit located in the upper section of the compartement
housing.
The temperature in the refrigerator and freezer
compartments is adjusted with the therostat
.
The control panel functions
The thermostat knob (depending on the model)
Adjusting temperature inside the appliance:
Knob in position
0/Off
: the appliance is
turned off
.
Knob in position
1-min
:
minimum
cooling intensity.
Knob in position
7-max
:
maximum
cooling intensity.
Recommended thermostat position is Med.
Note:
The internal temperatures are affected by the room
temperature, frequency of opening the doors, as well as location
of the appliance. Adjust the thermostat knob depending on these
factors.
Fan (depending on the model)
The
fan
gives more even temperature distribution inside the
refrigerator compartment, allowing better preservation of
stored food.
Important:
Do not obstruct the air intake area (6a) with food items.
Fan with a button
To fit the fan press the button (6b). It is advisable to activate
the fan when the ambient air temperature is over 27 ÷ 28°C
or if you perceive drops of water on the glass shelves or in the
severe humidity conditions.
Important:
The fan will run ONLY when the compressor is in
operation. Remember to turn off the fan when there is
a lower ambient air temperature.
Fan without a button
An electronic system automatically turn on and turn off the fan.
Important:
The fan will run ONLY when the compressor is in operation.
Light
- how to replace the bulb
Before replacing the bulb, remove the power plug from the
mains socket. Next:
1.
Hold the diffuser as shown and squeeze it slightly.
2.
Slide it towards the rear of the appliance
3.
Unscrew the light bulb as illustrated in the picture.